HOW TO CLEAN THE WATER INLET FILTER
This screen filter should be checked periodically and cleaned if necessary.
2.Clean filter by flushing it with water on both sides.
3.
1.Remove filter by grasping end and removing it from water inlet of pump as shown.
Filter Screen
NOTE: Do not operate pressure washer without filter properly installed.
STORAGE
ENGINE
Consult the Engine Owners Manual for the manufacturer's recommendations for storage.
PUMP
The manufacturer recommends using a pump protector/winterizer, such as DP80 when storing the unit for more than 30 days and/or when freezing temperatures are expected. DP80
is availabe at the store where the pressure washer was purchased. If a pump protector/winterizer is not available, RV antifreeze needs to be run through the pump as outlined in the steps below.
NOTE: Using a pump protector/ winterizer or RV antifreeze is to provide proper lubrication to the internal seals of the pump regardless of temperature or environment.
1.Obtain a funnel, 6 oz. (170 mL) of RV antifreeze and
Risk of property damage. Use only
RV antifreeze. Any other antifreeze is corrosive and can damage pump.
2.Disconnect spark plug wire.
3.Connect length of garden hose to water inlet of pump.
4.Add RV antifreeze to hose as shown.
5.Pull engine starter rope slowly several times until antifreeze comes out of
6.Remove garden hose from water inlet of pump.
7.Reconnect spark plug wire.
A20118 | 16- ENG |