Model LG & LD Pool and Spa Heater | Page 17 |
|
|
|
|
3B-1. Model LD (Direct Ignition)
FOR YOUR SAFETY READ BEFORE OPERATING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result, causing property damage, personal injury or loss of life.
A.This appliance does not have a pilot light. It is equipped with an ignition device which automatically lights the heater. Do NOT try to light the burners by hand.
B.BEFORE OPERATING, smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•Do not try to light any appliance
•Do not touch any electric switch; do not use any phone in your building.
•Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.
•If you cannot reach your gas supplier, call the fire department.
C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don't try to repair it, call a qualified service technician. Force or attempted repair may result in a fire or explosion.
D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.
OPERATING INSTRUCTIONS 
1.STOP! Read the safety information above on this label.
2.Set the thermostat to lowest setting and turn appliance switch to "OFF".
3.Turn off all electric power to the appliance.
4.This appliance is equipped with an ignition device which automatically lights the heater. Do not try to light the burners by hand.
5.Remove the heater door.
6.Turn gas control knob clockwise 
to "OFF".
7.Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow "B" in the safety information above on this label. If you don't smell gas, go to next step.
8.Turn gas control knob counterclockwise 
to "ON".
9.Replace control access panel
10.Turn on all electric power to appliance.
11.Set thermostat to desired setting and turn appliance switch from "OFF" to either "POOL" or "SPA".
12.If the appliance will not operate, check that
the filter pump is on, the filter is clean and water is flowing to the pool. Otherwise, follow the instructions "To Turn Off Gas To Appliance" and call your service technician or gas supplier.
TO TURN OFF GAS TO APPLIANCE
1. | Set the thermostat to lowest setting and turn | 3. | Turn gas control knob clockwise | to |
| appliance switch to "OFF". |
| "OFF". |
|
2. | Turn off all electric power to the appliance if | 4. | Replace control access panel. |
|
| service is to be performed. |
|
|
|