Zenoah BCX2600S manual If Someone Comes, Maintenance, Handling Fuel

Page 11

5.For safe operation

IF SOMEONE COMES

1.Guard against hazardous situations at all times. Warn adults to keep pets and children away from the area. Be careful if you are approached. Injury may result from flying debris.

2.If someone calls out or otherwise interrupts you while working, always be sure to turn off the engine before turning around.

MAINTENANCE

1.In order to maintain your product in proper working order, perform the maintenance and checking operations described in the manual at regular intervals.

2.Always be sure to turn off the engine before performing any maintenance or checking procedures.

WARNING

The metallic parts reach high temperatures immediately after stopping the engine.

3.When replacing the cutting attachment or any other part, or when replacing the oil or any lubricant, always be sure to use only RedMax products or products which have been certified by RedMax for use with the RedMax product.

4.In the event that any part must be replaced or any maintenance or repair work not described in this manual must be performed, please contact a representative from the store nearest RedMax authorized servicing dealer for assistance.

5.Do not use any accessory or attachment other than those bearing the RedMax mark and recommended for the unit.

6.Under no circumstances should you ever take apart the product or alter it in any way. Doing so might result in the product becoming damaged during operation or the product becoming unable to operate properly.

HANDLING FUEL

1.The engine of the RedMax product is designed to run on a raw fuel which is highly flammable gasoline. Never store cans of fuel or refill the

11

Image 11
Contents T3032-93110 BCX2600SPage Safety First Parts location Avertissement Position Symbols on the machineEmplacement Working Circumstance For safe operationWorking Condition Working Plan Starting the Engine Before Starting the EngineUsing the Product Handling Fuel MaintenanceIf Someone Comes Transportation Set up Balance Unit SE5 SE6 Installing Cutting Head SE5Section Oil / FuelRecommended OIL Type Adding OIL to CRANKCASE-INITIAL USEUSE of Fuel Additives Definition of Blended FuelsUSE of Blended Fuels OP1 OP2 OP3 Starting Engine OperationOP5 Adjusting Idling Speed OP4Adjusting the Wire Play OP5 OP4Trimming Grass and Weeds Adjusting the Line LengthOP6 Cutting Work Line Head Usage MA1 MA2 MA3 MA4 MaintenanceMaintenance Chart For safety reasons, do not use metalreinforced lineAIR Filter MA5 MA6 MA7Changing the OIL Wear gloves to prevent injury when handing the unitMA8 MA9 OIL Level Oil Fill Plug/Dipstick 2 O-Ring Top of DipstickRocker arm cover MA10 MA11 MA12 MA13 Change the oil as followValve to Rocker ARM Clearance Fuel filter Feeler gauge 2 Rocker arm Adjusting nut 4 GasketMA14 MA15 Fuel FilterTightening Torque Muffler MA16Spark Plug Specified plug is Champion RDZ19HGear Case MA18 MA17 MA18Spark Arrester Spark arresterCylinder Intake air cooling vent back MA19 MA20Storage Cleaning and storageCleaning Optional blade usage Cutting Method OPT4 OPT5 OPT6Bracket Handle What causes kick out OPT7 OPT8 OperationControlling Blade Bounce How you can maintain the best control How you can reduce the chance of kick outTransporting the Unit OPT9 Maintenance BladeProblem Cause Action Troubleshooting guideParts list 36  37  38  39  Manufacturer’s warranty coverage RedMax TRIMMER/BRUSHCUTTER Model BCX2600S Year Limited WarrantyLimites de la garantie