Zenoah BCX2600S MA16, Spark Plug, Specified plug is Champion RDZ19H, Tightening Torque Muffler

Page 25

9. Maintenance

MA16

.025 in

0.655mm

■SPARK PLUG

IMPORTANT

•Starting failure and mis-firing are often caused by a fouled spark plug. Clean the spark plug and check that the plug gap is in the correct range. For a replacement plug, use the correct type specified by RedMax. (MA16)

Specified plug is Champion RDZ19H

1.Stop the engine and allow it to cool. Pull the wire off of the spark plug.

2.Clean around the spark plug and remove it from the cylinder head. Use a 5/8 inch (16mm) socket to remove the plug.

3.Clean the electrode.

4.Set the plug gap at 0.025 in. (0.655mm) using a feeler gauge (MA16). Install a correctly gapped spark plug into the cylinder head.

•To install the spark plug, first turn the plug until it is finger tight, then tighten it a quarter turn more with a socket wrench.

TIGHTENING TORQUE:

■MUFFLER

WARNING

100~110 in-lbs (11.3~12.3 N.m.)

•Inspect periodically, the muffler for loose fasteners, any damage or corrosion. If any sign of exhaust leakage is found, stop using the machine and have it repaired immediately.

•Note that failing to do so may result in the engine catching on fire.

25 

Image 25

Contents T3032-93110 BCX2600SPage Safety First Parts location Avertissement Emplacement Symbols on the machinePosition Working Condition For safe operationWorking Circumstance Working Plan Starting the Engine Before Starting the EngineUsing the Product If Someone Comes MaintenanceHandling Fuel Transportation Set up Balance Unit SE5 SE6 Installing Cutting Head SE5Recommended OIL Type Oil / FuelAdding OIL to CRANKCASE-INITIAL USE SectionUSE of Blended Fuels Definition of Blended FuelsUSE of Fuel Additives OP1 OP2 OP3 Starting Engine OperationAdjusting the Wire Play OP5 Adjusting Idling Speed OP4OP4 OP5OP6 Cutting Work Line Head Usage Adjusting the Line LengthTrimming Grass and Weeds Maintenance Chart MaintenanceFor safety reasons, do not use metalreinforced line MA1 MA2 MA3 MA4AIR Filter MA5 MA6 MA7MA8 MA9 OIL Level Wear gloves to prevent injury when handing the unitOil Fill Plug/Dipstick 2 O-Ring Top of Dipstick Changing the OILValve to Rocker ARM Clearance MA10 MA11 MA12 MA13 Change the oil as followRocker arm cover MA14 MA15 Feeler gauge 2 Rocker arm Adjusting nut 4 GasketFuel Filter Fuel filterSpark Plug MA16Specified plug is Champion RDZ19H Tightening Torque MufflerSpark Arrester MA17 MA18Spark arrester Gear Case MA18Cylinder Intake air cooling vent back MA19 MA20Cleaning Cleaning and storageStorage Optional blade usage Bracket Handle OPT4 OPT5 OPT6Cutting Method Controlling Blade Bounce OPT7 OPT8 OperationWhat causes kick out How you can maintain the best control How you can reduce the chance of kick outTransporting the Unit OPT9 Maintenance BladeProblem Cause Action Troubleshooting guideParts list 36  37  38  39  Manufacturer’s warranty coverage RedMax TRIMMER/BRUSHCUTTER Model BCX2600S Year Limited WarrantyLimites de la garantie