Zenoah BCX2600S manual Set up

Page 13

6. Set up

SE1

SE2

SE3

(1)

SE4

(1)

(2)

(3)

■MOUNTING ENGINE (SE1)

1.Push the driveshaft housing toward the clutch housing and rotate it by hand to check that the driveshaft is engaged with the gears.

2.Insert the driveshaft housing into the clutch housing until it bottoms, and align the positioning holes on the clutch housing and the shaft tube and install the screw. When difficult to engage, twist the engine slightly.

3.Fasten the clamp securely with two screws.

IMPORTANT

Tighten the screws gradually by turns.

■CONNECTING THROTTLE WIRE

1. Remove the air cleaner cover.

2. Connect the end of the throttle wire to the joint on the top of the carburetor. (SE2)

■CONNECTING SWITCH WIRES

•Connect the switch wires between the engine and the main unit. Connect the wire to the same color receiver on the main unit.

■INSTALLING HANDLE

•Mount the handle to the shaft tube and clamp it at a location that is comfortable to you. (SE3)

(1) About 19 inches (48cm)

■INSTALLING DEBRIS GUARD

•Put the debris guard on the gear box, attach it with the 4 screws and hardware provided. (SE4)

(1)Debris Guard

(2)Plate

(3)Screw

13 

Image 13

Contents T3032-93110 BCX2600SPage Safety First Parts location Avertissement Emplacement Symbols on the machinePosition Working Condition For safe operationWorking Circumstance Working Plan Starting the Engine Before Starting the EngineUsing the Product If Someone Comes MaintenanceHandling Fuel Transportation Set up Balance Unit SE5 SE6 Installing Cutting Head SE5Recommended OIL Type Oil / FuelAdding OIL to CRANKCASE-INITIAL USE SectionUSE of Blended Fuels Definition of Blended FuelsUSE of Fuel Additives OP1 OP2 OP3 Starting Engine OperationAdjusting the Wire Play OP5 Adjusting Idling Speed OP4OP4 OP5OP6 Cutting Work Line Head Usage Adjusting the Line LengthTrimming Grass and Weeds Maintenance Chart MaintenanceFor safety reasons, do not use metalreinforced line MA1 MA2 MA3 MA4AIR Filter MA5 MA6 MA7MA8 MA9 OIL Level Wear gloves to prevent injury when handing the unitOil Fill Plug/Dipstick 2 O-Ring Top of Dipstick Changing the OILValve to Rocker ARM Clearance MA10 MA11 MA12 MA13 Change the oil as followRocker arm cover MA14 MA15 Feeler gauge 2 Rocker arm Adjusting nut 4 GasketFuel Filter Fuel filterSpark Plug MA16Specified plug is Champion RDZ19H Tightening Torque MufflerSpark Arrester MA17 MA18Spark arrester Gear Case MA18Cylinder Intake air cooling vent back MA19 MA20Cleaning Cleaning and storageStorage Optional blade usage Bracket Handle OPT4 OPT5 OPT6Cutting Method Controlling Blade Bounce OPT7 OPT8 OperationWhat causes kick out How you can maintain the best control How you can reduce the chance of kick outTransporting the Unit OPT9 Maintenance BladeProblem Cause Action Troubleshooting guideParts list 36  37  38  39  Manufacturer’s warranty coverage RedMax TRIMMER/BRUSHCUTTER Model BCX2600S Year Limited WarrantyLimites de la garantie