Removing Soap Film and Hard Water Deposits

8.Replace the impeller and impeller cap on each jet assembly by rotating them counterclockwise.

Cross-threading the jet assembly onto the casing may cause damage to the whirlpool motor. After installation, ensure that the jet assembly is flush against the jet casing.

9.Assemble each jet assembly to the jet casings.CAUTION

A.Position the Sanijet® logo and red indicator at the 11 o’clock position.

B.Insert the jet assembly into the jet casing and rotate the jet assembly clockwise until it locks into place.

5 OPERATION

Jet Casing

Sanijet™

Logo

Jet

Assembly

Removing Soap Film and Hard Water Deposits

Use a commercially available cleaner such as Invacare Heavy Duty Cleaner. Remove the jet assemblies. Remove the impeller caps. Thoroughly spray the exposed surfaces, including the jet casings. Use a long handled soft brush or similar product to wipe down all surfaces and allow the heavy duty cleaner to remain in contact with the exposed surfaces for approximately ten minutes. Rinse off surfaces using the shower wand, adjusted to spray position.

Removing Calcium Deposits, Scale and Lime Build-up

Spray a commercially available cleaner (full strength) for the intended application on all surfaces to be cleaned. Allow the cleaner to remain in contact with surfaces for at least five minutes to as long as 12 hours. Rinse off surfaces using the shower wand, adjusted to the spray position. Use the cleaner according to the manufacturer's instructions.

Part No. 1167456

Invacare® TheraPure™Supine Whirlpool Tubs