Filling the Tub, Using the Shower/Massage Wand

5 OPERATION

5.4Filling the Tub

1.Use the drain plug to close the drain.

2.Position the resident (on the stretcher lift) in the tub.

3.Push the tub fill button once to start auto-fill.

The tub will fill to a predetermined level. To stop the tub from filling during auto-fill, press the fill button a second time (there will be a five second delay). After the tub has auto-filled, push in and hold the tub fill button to add additional water.

4.Use the water temperature control valve to adjust the water temperature while watching the flow water thermometer. Test the water temperature with your hand.

5.5Using the Shower/Massage Wand

These instructions are to be done while holding the shower/massage wand over the tub.

1.Turn the shower/massage on by pushing the ON/OFF button.

2.Adjust the water temperature using the water temperature valve while watching the flow water thermometer. Test the temperature with your hand.

3.Adjust the flow of the water by turning the flow control.

4.Adjust the shower spray by rotating the shower wand head.

5.Turn the shower/massage off by pressing the ON/OFF button again.

Refer to the following chart for shower head adjustment settings.

Stream

Pulse Massage

Shower Spray

Mixture of Shower Spray and Pulse Massage

Flow Control serves as a volume control and water saver.

The use of the Flow Control permits the reduction of water flow without the need for readjustment of water temperature during bathing. A trickle of water through the Flow Control when in the closed position is normal.

Part No. 1167456

Invacare® TheraPure™Supine Whirlpool Tubs