Genie TMZ-50, TMZ-30 manual Battery Safety Burn Hazards, Explosion Hazards, Tip-over Hazard

Page 10

Operator's Manual

First Edition • Third Printing

 

 

 

 

SAFETY RULES

Battery Safety

Burn Hazards

Batteries contain acid. Always wear protective clothing and eyewear when working with batteries.

Avoid spilling or contacting battery acid. Neutralize battery acid spills with baking soda and water.

Explosion Hazards

Keep sparks, flames and lighted tobacco away from batteries. Batteries emit an explosive gas.

The covers should be open during the entire charging cycle.

Do not contact the battery terminals or the cable clamps with tools that may cause sparks.

Component Damage Hazards

Do not use any battery charger greater than 24V to charge the batteries.

Do not expose the batteries or the charger to water or rain.

Electrocution Hazards

Connect the battery charger to a grounded, AC 3-wire electrical outlet only.

Inspect daily for damaged cord, cables and wires. Replace damaged items before operating.

Avoid electrical shock from contact with battery terminals. Remove all rings, watches and other jewelry.

Tip-over Hazard

Models with batteries: Do not use batteries that weigh less than the original equipment. Batteries are used as counterweight and are critical to machine stability. Each battery must weigh 75 pounds / 34 kg.

Lifting Hazard

Use the appropriate number of people and proper lifting techniques when lifting batteries.

8

Genie TMZ-50/30 & Genie TMZ-17/10

Part No. 72896

Image 10
Contents Operator’s Manual Contents Contact usSafety Rules Do Not Operate UnlessElectrocution Hazards Tip-over HazardsBodily Injury Hazard Lifting Hazards Collision HazardsComponent Damage Hazards Explosion and Fire HazardsDamaged Machine Hazards Towing HazardsFall Hazards Personnel Lifting Configuration Tip-over HazardsMaterial Lifting Configuration Collision Hazards Collision HazardOptional Drive System Tip over Hazards Decal LegendTip-over Hazard Battery Safety Burn HazardsExplosion Hazards Lifting HazardControls Platform Control PanelGround Control Panel Drive Control Panel option Pre-operation Inspection FundamentalsPre-operation Inspection PRE-OPERATION InspectionMaintenance Symbols Legend MaintenanceCheck the Hydraulic Oil Level Observe and Obey Check the Engine Oil Level Engine ModelsScheduled Maintenance Check the Tires and WheelsFunction Tests SetupFunction Tests Test Outrigger Interlock At the Ground ControlsTest Emergency Stop Test the Boom FunctionsTest Machine Functions At the Platform ControlsTest the Horn Test the Drive and Steering If equippedWorkplace Inspection Workplace InspectionEmergency Stop Set upOperating Instructions Only use the machine as it was intendedTransport Towing InformationPrimary boom retract function Models with Engines Manual LoweringDC Models Manual Lowering All other functionsOperation from Platform Operation from GroundTo Position Platform Transport Not attached to a tow vehicle Optional Drive System Operating InstructionsBacking Up with Trailer If equipped with surge brake After Each UseMaterial Lifting Configuration Observe and Obey Material Lifting Configuration Set upTo Charge Battery Battery and Charger Instructions Observe and ObeyDry Battery Filling Charging Instructions Voltage ConversionDecals Decal InspectionDecals Specifications Reporting Safety Defects Reporting Safety DefectsGenie Industries PO Box Redmond, WA Distributed By