Operator's Manual | First Edition • Third Printing |
|
|
|
|
SAFETY RULES
Collision Hazards
Be aware of boom position when rotating the turntable.
The machine must be on a level surface or secured before releasing the parking brake.
Use the parking brake to control the speed of the machine when pushing a machine that is not attached to a tow vehicle.
Check the work area for overhead obstructions or other possible hazards.
It is recommended that operators wear an approved hard hat when operating the machine.
Do not lower the boom unless the area below is clear of personnel and obstructions.
Do not operate a boom in the path of any crane unless the controls of the crane have been locked out and/or precautions have been taken to prevent any potential collision.
No stunt driving or horseplay while operating the machine.
Component Damage Hazards
Do not use the machine as a ground for welding.
Do not fully lower the booms unless the booms are aligned with the tongue. The booms must be lowered onto the boom rests.
Do not use any battery or charger greater than 12V to
Lifting Hazards
Use proper lifting techniques to move the machine.
Use proper lifting techniques when installing or removing the platform.
Explosion and Fire Hazards
Do not start the engine if you smell or detect liquid petroleum gas (LPG), gasoline, diesel fuel or other explosive substances.
Do not refuel the machine with the engine running.
Refuel the machine and charge the battery only in an open,
Do not operate the machine in hazardous locations or locations where potentially flammable or explosive gases or particles may be present.
4 | Genie | Part No. 72896 |