Briggs & Stratton 30238 owner manual Receptacles, Cold Weather Operation, Stopping the Engine

Page 10

Stopping the Engine

1.Turn OFF and unplug all electrical loads from generator panel receptacles. NEVER start or stop engine with electrical devices plugged in and turned ON.

2.Let engine run at no-load for several minutes to stabilize internal temperatures of engine and generator.

3.Turn engine off according to instructions given in the engine owner’s manual.

4.Move fuel valve to “Off” position.

RECEPTACLES

CAUTION

Receptacles may be marked with rating value greater than generator output capacity.

•NEVER attempt to power a device requiring more amperage than generator or receptacle can supply.

•DO NOT overload the generator. See “Don’t Overload Generator”.

120/240 Volt AC, 20 Amp, Locking Receptacle

Use a NEMA L14–20 plug with this receptacle. Connect a 4–wire cord set rated for 250 Volt AC loads at 20 Amps (or greater) (Figure 5).You can use the same 4–wire cord if you plan to run a 120 Volt load.

Figure 5 — 120/240 Volt AC, 20 Amp Receptacle

4-Wire Cord Set

240V

120V 120V

W (Neutral)

Y (Hot)

X (Hot)

NEMA L14-20

Ground (Green)

OPERATION

This receptacle powers 120/240 Volt AC, 60 Hz, single phase loads requiring up to 3,750 watts of power

(3.75 kW) at 15.6 Amps for 240 Volts or two independent 120 Volt loads at 15.6 Amps each.The outlet is protected by push–to–reset circuit breakers.

120 Volt AC, 20 Amp, Duplex Receptacles

Each duplex receptacle (Figure 6) is protected against overload by a push–to–reset circuit breaker.

Figure 6 — 120 Volt, 20 Amp Duplex Receptacle

Use each receptacle to operate 120 Volt AC, single–phase, 60 Hz electrical loads requiring up to 2,400 watts (2.4 kW) at 20 Amps of current. Use cord sets that are rated for 125 Volt AC loads at 20 Amps (or greater).

COLD WEATHER

OPERATION

Under certain weather conditions (temperatures below 40°F [4°C] combined with high humidity), your generator may experience icing of the carburetor and/or the crankcase breather system.To reduce this problem, you need to perform the following:

1.Make sure generator has clean, fresh fuel.

2.Open fuel valve (turn valve to open position).

3.Use SAE 5W-30 oil (synthetic preferred, see engine manual).

4.Check oil level daily or after every eight (8) hours of operation.

5.Maintain generator following “Maintenance Schedule” in engine manual.

6.Shelter unit from elements.

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents 030238 Safety Rules Table of ContentsEquipment Description When Operating Equipment When Adding or Draining FuelWhen Starting Equipment When Transporting or Repairing EquipmentWhen Adjusting or Making Repairs to Your Generator When Testing for Engine SparkKnow Your Generator Install Wheel Kit AssemblyRemove Generator From Carton Before Starting the Engine When Adding FuelInstall fuel cap and wipe up any spilled fuel Add Engine OilSystem Ground Using the GeneratorConnecting to a Building’s Electrical System Generator LocationOperating Generator Connecting Electrical LoadsStarting the Engine Stopping the Engine ReceptaclesCold Weather Operation 120/240 Volt AC, 20 Amp, Locking ReceptacleRemove shelter when temperatures are above 40F 4C Permanent Cold Weather ShelterDont Overload Generator Power ManagementCapacity Engine Maintenance SpecificationsGeneral Maintenance Recommendations Generator MaintenanceStorage TroubleshootingProblem Cause Correction Generator StorageConsumer Use Years Years or YearDescription DE L Équipement Symboles de Danger et MoyensVeuillez Conserver CES Instructions Table DES Matières Règles DE SécuritéLorsque Léquipement Fonctionne Lors DE Lajout OU DE LA Vidange DU CarburantLors DU Démarrage DE Léquipement Lorsque Vous Transportez OU Réparez LéquipementLorsque Vous Réglez OU Réparez Votre Générateur Lors DE Tests Dallumage DU MoteurBouchon de remplissage dhuile Ajoutez de lhuile au Connaissez Votre GénérateurMoteur à cet endroit Assemblage Installe la Roue la TrousseRéférez-vous à la et installez les roues comme suit Enlever le générateur de la boiteAjoutez de lessence Avant LE Démarrage DU MoteurAjoutez de lhuile à moteur Lors DE Lajout DU CarburantMise à la terre du système Emplacement de la GénératriceUtilisation DE LA Génératrice Branchement au système électrique dun édificeDémarrage du Moteur Utilisation DU GénérateurBranchement des Charges Électriques Arrêt du Moteur Prises DE CourantFonctionnement PAR Temps Froid Prise à Verrouillage de 120/240 Volts c.a., 20 AmpèresAbri Permanent Pour Temps Froids VentGestion de la Consommation NE PAS Surchargez GénérateurCapacité ExempleEntretien du Moteur Recommandations Générales D’ENTRETIENSpécifications Entretien du GénérateurRemisage du Générateur DépannageRemisage Remisage du MoteurGarantie Limitée Reglas DE Seguridad Conserve Estas Instrucciones Tabla DE ContenidosDescripción DEL Equipo AdvertenciaCuando Opere EL Equipo Cuando Añada Combustible O Vacíe EL DepósitoCuando Ponga EN Funcionamiento EL Equipo Cuando Transporte O Repare EL EquipoCuando Ajuste O Haga Reparaciones a SU Generador PrecauciónCuando Pruebe LA Bujía DEL Motor Tomacorriente Dobles de 120 Voltios AC, 20 Amp Conozca SU GeneradorTapa del Depósito del Aceite Llene el motor con aceite Tomacorriente con Dispositivo de Seguridad deInstale el Juego de Ruedas MontajePara Retirar El Generador De La Caja Agregue Combustible Antes DE Darle Arranque AL MotorAgregar Aceite al Motor Coloque la generador sobre una superficie niveladaConexión al Sistema Eléctrico de un Edificio USO DEL GeneradorTierra del Sistema Ubicación del GeneradorConexion De Cargas Electricas Operando EL GeneradorEncienda el Motor No Sobrecargue EL GENERADOR.Vea No Sobrecargue GeneradorParado Del Motor Receptáculos PrecauciónOperación Durante UN Clima Frío 120/240 Voltios AC, 20 Amp, Receptáculo de SeguridadFigura 23 Refugio Frío Permanente del Tiempo Control de la Energía No Sobrecargue GeneradorCapacidad EjemploMantenimiento del Motor EspecificacionesRecomendaciones Generales DE Mantenimiento Mantenimiento del GeneradorAlmacenando el Motor AlmacenamientoAlmacenando el Generador Otras Sugerencias Para el AlmacenandoDiagnositicos DE Averías Garantía Limitada

30238 specifications

The Briggs & Stratton 30238 is a powerful and reliable generator, widely recognized for its exceptional performance and durable construction. Designed for residential and light commercial use, this generator is equipped with features that make it an ideal choice for both backup power during outages and for powering tools and appliances on job sites.

One of the standout features of the Briggs & Stratton 30238 is its robust engine. Powered by a 7,500-watt starting and 6,000-watt running capability, it is capable of handling heavy loads with ease. The generator is equipped with a strong OHV (Overhead Valve) engine that offers improved fuel efficiency and lower emissions, ensuring it runs cleanly and efficiently.

Another key characteristic of the 30238 is its large fuel tank. With a capacity of 5 gallons, this generator provides an impressive runtime of up to 9 hours at 50% load. This means users can rely on the 30238 for extended periods without frequent refueling, a crucial feature during extended power outages or when working on-site.

The Briggs & Stratton 30238 also boasts a user-friendly control panel with multiple outlets for convenience. It includes two 120V 20A household outlets, one 120V 30A locking outlet, and even a 12V DC outlet, allowing users to power various appliances simultaneously. This versatility makes it easy to connect everything from refrigerators to power tools, ensuring you have what you need when you need it.

In terms of safety and ease of use, the generator is equipped with a low-oil shutdown feature that automatically turns off the engine when the oil level becomes too low. This helps prevent engine damage and prolongs the life of the generator. Additionally, the unit features a recoil start for easy operation, making it accessible to users of all experience levels.

Durability is another hallmark of the Briggs & Stratton 30238. It features a sturdy steel frame designed to withstand tough conditions, making it ideal for use in various environments. Coupled with a compact design, the generator is also relatively easy to transport, facilitating mobility when it is needed the most.

In summary, the Briggs & Stratton 30238 is a powerful and reliable generator that combines performance, efficiency, and user-friendly features. With its strong engine, extended runtime, versatile outlets, safety features, and durable construction, it stands out as an excellent choice for anyone in need of reliable backup power or a dependable portable generator for various tasks.
Top Page Image Contents