Briggs & Stratton 30228 Operating Generator, Starting the Engine, Jump Start Procedure

Page 9

OPERATION

8000W Portable Generator

PowerBOSS™

 

 

 

OPERATING THE

GENERATOR

CAUTION

Exceeding generator’s wattage/amperage capacity can damage generator and/or electrical devices connected to it.

•See “Don’t Overload Generator”.

•Start generator and let engine stabilize before connecting electrical loads.

•Connect electrical loads in OFF position, then turn ON for operation.

•Turn electrical loads OFF and disconnect from generator before stopping generator.

IMPORTANT: Always unplug the battery float charger before starting the generator.

Starting the Engine

Disconnect all electrical loads from the generator. Use the following start instructions:

1.Make sure unit is on a level surface.

IMPORTANT: Failure to start and operate unit on a level surface will cause the unit not to start or shut down during operation.

2.Turn the fuel valve to the “On” position (Figure 5).The fuel valve handle should be vertical (pointing toward the ground) for fuel to flow.

Figure 5 — Fuel Valve

Fuel Valve is shown in “On” position

3.Set Run/Stop switch to “Run” position (Figure 6).

Figure 6 — Run/Stop Switch

4.Follow start instructions given in engine owner’s manual. Push and hold the Ignition switch in start position (Figure 7) until generator starts.To prolong the life of starter components, DO NOT hold Ignition switch in start position for more than 15 seconds, and pause for at least 1 minute between starting atempts.

Figure 7 — Ignition Switch

NOTE: If engine starts but fails to run, or if unit shuts down during operation, make sure unit is on a level surface and check for proper oil level in crankcase.This unit may be equipped with a low oil protection device. See engine manual.

WARNING

Running engines produce heat.Temperature of muffler and nearby areas can reach or exceed 150°F (65°C).

Severe burns can occur on contact.

Combustible debris, such as leaves, grass, brush, ect. can catch fire.

•DO NOT touch hot surfaces.

•Allow equipment to cool before touching.

•The generator must be at least 5 feet from structures having combustible walls and/or other combustible materials.

•Keep at least 3 feet of clearance on all sides of generator for adequate cooling, maintenance and servicing.

•In the State of California a spark arrester is required by law (Section 4442 of the California Public Resources Code). Other states may have similar laws. Federal laws apply on federal lands. If you equip the muffler with a spark arrester, it must be maintained in effective working order.

Jump Start Procedure

If generator’s starting battery fails, use following instructions to jump start generator.You can jump start generator using any 12 Volt automotive or utility style storage battery.

1.Unscrew fuse holder and remove generator’s 10 Amp in-line fuse (Figure 8).Verify fuse is good or replace with a known good fuse. Reinstall fuse in fuse holder.

Figure 8 — In-Line Fuse

9

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Model / Modelo 030228 8000W Table of Contents Safety RulesEquipment Description When Starting Equipment When Adding or Draining FuelWhen Operating Equipment When Transporting or Repairing EquipmentWhen Testing for Engine Spark When Adjusting or Making Repairs to Your GeneratorKnow Your Generator Assembly Install Wheel KitRemove Generator From Carton When Adding Fuel Check Battery / Attach Negative Battery WireBefore Starting the Engine Add FuelConnecting to a Building’s Electrical System Using the GeneratorSystem Ground Generator LocationJump Start Procedure Operating GeneratorStarting the Engine Connecting Electrical Loads How to Use the Battery ChargerStopping the Engine Permanent Cold Weather Shelter Cold Weather OperationReceptacles Volt AC, 50 Amp Receptacle120/240 Volt AC, 30 Amp, Locking Receptacle Volt AC, 20 Amp, Duplex Receptacle Volt AC, 30 Amp Locking ReceptaclePower Management DON’T Overload GeneratorCapacity General Maintenance Recommendations SpecificationsStorage Generator StorageEngine Storage Other Storage Tips Problem Cause Correction TroubleshootingPowerBOSS Limited Warranty Descripción DEL Equipo Conserve Estas Instrucciones Tabla DE ContenidosReglas DE Seguridad AdvertenciaCuando Ponga EN Funcionamiento EL Equipo Cuando Añada Combustible O Vacíe EL DepósitoCuando Opere EL Equipo Cuando Transporte O Repare EL EquipoPrecaución Cuando Ajuste O Haga Reparaciones a SU GeneradorCuando Pruebe LA Bujía DEL Motor Conozca SU Generador Montaje Para Retirar El Generador De La CajaInstale el Juego de Ruedas Agregar Aceite al Motor Antes DE Darle Arranque AL MotorAgregue Combustible Para instalarTierra del Sistema USO DEL GeneradorConexión al Sistema Eléctrico de un Edificio Ubicación del GeneradorEncienda el Motor Operando EL Generador PrecauciónConexion De Cargas Electricas Procedimiento de Arranque en PuenteParado Del Motor No Sobrecargue GENERADOR. Vea No Sobrecargue GeneradorCómo al Uso el Corcel de Batería Operación Durante UN Clima FríoVoltios AC, 50 Amperios Receptáculo Receptáculos Precaución120/240 Voltios AC, 30 Amperios, Receptáculo de Seguridad Volt AC, 20 Amperios, Receptáculos DoblesTomacorrientes de 120 Voltios AC, 30 Amperios Capacidad No Sobrecargue GeneradorControl de la Energía EjemploRecomendaciones Generales DE Mantenimiento EspecificacionesAlmacenando el Generador AlmacenamientoAlmacenando el Motor Otras Sugerencias Para el AlmacenandoDiagnositicos DE Averías Garantía Limitada

30228 specifications

The Briggs & Stratton 30228 is a high-performance generator designed for a variety of residential and commercial applications. Known for its reliability and durability, this portable generator is an excellent choice for anyone in need of backup power during outages or for outdoor activities that require electricity.

One of the standout features of the Briggs & Stratton 30228 is its powerful engine. Equipped with a 479cc OHV (Overhead Valve) engine, it delivers a robust output of 7,500 running watts and up to 9,375 starting watts. This ensures that users can run multiple appliances simultaneously, making it suitable for powering everything from refrigerators and air conditioners to power tools and more.

The generator's design incorporates advanced technologies aimed at maximizing efficiency and usability. One notable feature is its SureStart technology, which ensures easy starting even in low temperatures or after prolonged storage. The automatic idle control feature helps reduce fuel consumption by adjusting the engine speed to match the electrical load, ultimately saving on operational costs and extending run time.

Additionally, the Briggs & Stratton 30228 is built with a heavy-duty steel frame to protect the engine and components from rough handling, ensuring long-lasting performance. Its 7.5-gallon fuel tank provides extended run times, capable of delivering up to 9 hours of continuous power at a 50% load.

The generator features multiple outlets, including four 120V AC outlets, one 120/240V twist-lock outlet for heavy-duty applications, and a circuit breaker for added safety protection. Users will appreciate the ease of transport thanks to its built-in foldable handles and rugged wheels, enabling smooth mobility across various terrains.

Overall, the Briggs & Stratton 30228 combines powerful performance with advanced features and durability, making it an ideal solution for those looking for a reliable power source for emergencies or outdoor activities. Its user-friendly design and efficiency make it a top contender in the portable generator market, appealing to both casual users and professionals alike. Whether for home use or job site applications, this generator proves to be a dependable companion, ensuring that power is just a pull start away.
Top Page Image Contents