Briggs & Stratton 30219 manual Operating Generator, Starting the Engine

Page 9

OPERATION

OPERATING THE

GENERATOR

Starting the Engine

Disconnect all electrical loads from the generator. Use the following start instructions:

1.Make sure unit is on a level surface.

2.Turn fuel valve to “On” position (Figure 4). Fuel valve handle should be vertical (pointing toward ground) for fuel to flow.

Figure 4 — Fuel Valve

Fuel Valve is shown in the On position

3.Set on/off switch to “On” position (Figure 5).

Figure 5 — On/Off Switch

Switch is shown in

“On” position

4.Place choke lever in “Choke” position (Figure 6).

Figure 6 — Choke Lever

Choke Lever shown in “Choke” position

5.Grasp recoil handle and pull slowly until slight resistance is felt.Then pull handle rapidly to overcome compression, prevent kickback and start engine.

WARNING

Rapid retraction of starter cord (kickback) will pull hand and arm toward engine faster than you can let go.

Broken bones, fractures, bruises or sprains could result.

•When starting engine, pull cord slowly until resistance is felt and then pull rapidly to avoid kickback.

•NEVER start or stop engine with electrical devices plugged in and turned on.

IMPORTANT: If excessive fuel is present in the air/fuel mixture causing a “flooded” condition, move choke lever to “Run” position and pull handle repeatedly until engine starts.

6.Move choke lever to “Run” position a short distance at a time over several seconds in warm weather or minutes in cold weather. Let engine run smoothly before each change. Operate with choke in “Run” position.

WARNING

Running engines produce heat.Temperature of muffler and nearby areas can reach or exceed 150°F (65°C).

Severe burns can occur on contact.

Exhaust heat/gases can ignite combustibles, structures or damage fuel tank causing a fire.

•DO NOT touch hot surfaces and avoid hot exhaust gases.

•Allow equipment to cool before touching.

•Keep at least 5 ft. (152 cm) clearance on all sides of generator including overhead.

•Code of Federal Regulation (CFR) Title 36 Parks, Forests, and Public Property require equipment powered by an internal combustion engine to have a spark arrester, maintained in effective working order, complying to USDA Forest service standard 5100-1C or later revision. In the State of California a spark arrester is required under section 4442 of the California Public resources code. Other states may have similar laws.

9

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Starting Watts Operator’s Manual Manual del OperarioCall Generator Helpline Llame Línea Directa del Generador Table of Contents Safety RulesEquipment Description When Starting Equipment When Adding or Draining FuelWhen Operating Equipment When Transporting or Repairing EquipmentWhen Testing for Engine Spark When Adjusting or Making Repairs to Your GeneratorKnow Your Generator Install Wheel Kit AssemblyRefer to and install the wheel kit as follows Unpacking the GeneratorAdd Engine Oil Before Starting EngineAdd Fuel Type of FuelConnecting to a Building’s Electrical System Using the GeneratorSystem Ground Generator LocationStarting the Engine Operating GeneratorReceptacles Connecting Electrical LoadsGenerator Adapter Cord SET Stopping the EngineDont Overload Generator Power ManagementCapacity ExampleGenerator Specifications Product SpecificationsPower Ratings Engine SpecificationsGenerator Maintenance Generator CleaningGeneral Recommendations Engine Maintenance Service Air CleanerOil Clean Spark Arrester Screen Clean/Replace Spark PlugTo service the air cleaner, follow these steps Changing Engine OilCarburetor Adjustment Clean and inspect the spark arrester as followsAir Cooling System Long Term Storage Instructions StorageProtect Fuel System GeneratorTroubleshooting Page Owner’s Warranty Responsibilities Emissions Control System WarrantyPage Page Limited Warranty Descripción DEL Equipo Tabla DE ContenidosReglas DE Seguridad AdvertenciaCuando Ponga EN Funcionamiento EL Equipo Cuando Añada Combustible O Vacíe EL DepósitoCuando Opere EL Equipo Cuando Transporte O Repare EL EquipoPrecaución Cuando Ajuste O Haga Reparaciones a SU GeneradorCuando Pruebe LA Bujía DEL Motor Conozca SU Generador Tapa del Depósito del Aceite Llene el motor con aceiteTomacorriente Dobles de 120 Voltios AC, 20 Amp Montaje Desembalaje del GeneradorInstale el Juego de Ruedas Agregar Aceite al Motor Antes DE Darle Arranque AL MotorAgregue Combustible Cuando Añada CombustibleTierra del Sistema USO DEL GeneradorConexión al Sistema Eléctrico de un Edificio Ubicación del GeneradorEncienda el Motor Operando EL GeneradorReceptáculos Precaución Juego DE Cables DEL Adaptador DEL GeneradorConexion De Cargas Electricas Parado Del MotorCapacidad No Sobrecargue GeneradorControl de la Energía EjemploEspecificaciones DEL Producto Información Técnica Sobre EL MotorEspecificaciones del Generador Potencia NominalMantenimiento DEL Recomendaciones GeneralesGenerador Limpieza del GeneradorMantenimiento DEL Motor Advertencia AceiteServicio del Depurador de Aire Limpie/Reemplace la Bujía Cambio de Aceite del MotorLimpie la Pantalla Apagachispas Sistema de Refrigeración de Aire Ajuste del CarburadorLimpie e inspeccione el apagachispas de la siguiente manera Almacenamiento Para Periodos Prolongados AlmacenamientoProteja el Sistema de Combustible GeneradorDiagnositicos DE Averías Problemo Causa AccionNotas Garantía DEL Sistema DE Control DE Emisiones = 250 horas, B = 500 horas y a = 1000 horas Uso comercial Uso del consumidor

30219 specifications

The Briggs & Stratton 30219 is a highly regarded gasoline-powered generator that epitomizes reliability and performance for both residential and small commercial applications. This model is particularly popular among homeowners who require a dependable source of backup power during outages or those who want to power outdoor events and tools.

One of the standout features of the Briggs & Stratton 30219 is its impressive power output. With a 3,200 running watts and a peak output of 3,750 watts, it is capable of powering essential home appliances, such as refrigerators, heating systems, and quickly rechargeable devices. This capability makes it an excellent choice for emergency power solutions, ensuring that users can maintain comfort and functionality during unexpected power interruptions.

At the heart of the 30219 generator is a robust engine designed for longevity and efficiency. The 162cc OHV (Overhead Valve) engine provides a strong performance while maintaining fuel efficiency, allowing users to maximize their runtime. This generator is engineered with a 1.5-gallon fuel tank, providing up to 8 hours of continuous operation at 50% load, which is essential when you need consistent power without frequent refueling.

In terms of portability, the Briggs & Stratton 30219 incorporates a compact and lightweight design. It is equipped with a sturdy handle and wheels, making it easy to transport from one location to another. This is particularly beneficial for users who may need to move the generator for outdoor activities, construction sites, or emergency situations.

Safety is also a vital concern for users during operation. The Briggs & Stratton 30219 is equipped with a built-in low-oil shutdown feature, which automatically turns off the engine when oil levels become too low. This helps to prevent engine damage and extends the life of the generator. Additionally, it includes multiple outlets, providing versatility for connecting various devices while ensuring that users can power multiple items simultaneously.

Overall, the Briggs & Stratton 30219 generator is a powerful, efficient, and portable solution suitable for a variety of power needs. With its durable construction, reliable performance, and user-friendly features, it continues to earn a reputation as one of the best choices on the market for those seeking dependable backup power. Whether experiencing an outage or powering outdoor activities, the 30219 generator stands ready to perform.
Top Page Image Contents