Briggs & Stratton 30205 manual Using the Generator, System Ground, Generator Location

Page 8

OPERATION

USING THE GENERATOR

System Ground

The generator has a system ground that connects the generator frame components to the ground terminals on the AC output receptacles.The system ground is connected to the AC neutral wire (the neutral is bonded to the generator frame).

Special Requirements

There may be Federal or State Occupational Safety and Health Administration (OSHA) regulations, local codes, or ordinances that apply to the intended use of the generator. Please consult a qualified electrician, electrical inspector, or the local agency having jurisdiction.

•In some areas, generators are required to be registered with local utility companies.

Generator Location

Generator Clearance

WARNING

Exhaust heat/gases can ignite combustibles, structures or damage fuel tank causing a fire.

•Keep at least 5 ft. (152 cm) clearance on all sides of generator including overhead.

Place generator in a well ventilated area, which will allow for removal of deadly exhaust gas. DO NOT place generator where exhaust gas could accumulate and enter inside or be drawn into a potentially occupied building. Ensure exhaust gas is kept away from any windows, doors, ventilation intakes or other openings that can allow exhaust gas to collect in a confined area (Figure 4). Prevailing winds and air currents should be taken into consideration when positioning generator.

•If the generator is used at a construction site, there may be additional regulations which must be observed.

Connecting to a Building’s Electrical System

Connections for standby power to a building’s electrical system must be made by a qualified electrician.The connection must isolate the generator power from utility power, and must comply with all applicable laws and electrical codes.

WARNING

Generator produces powerful voltage.

Failure to isolate generator from power utility can result in death or injury to electric utility workers due to backfeed of electrical energy.

•When using generator for backup power, notify utility company. Use approved transfer equipment to isolate generator from electric utility.

•Use a ground fault circuit interrupter (GFCI) in any damp or highly conductive area, such as metal decking or steel work.

•DO NOT touch bare wires or receptacles.

•DO NOT use generator with electrical cords which are worn, frayed, bare or otherwise damaged.

•DO NOT operate generator in the rain or wet weather.

•DO NOT handle generator or electrical cords while standing in water, while barefoot, or while hands or feet are wet.

•DO NOT allow unqualified persons or children to operate or service generator.

WARNING

Running generator gives off carbon monoxide, an odorless, colorless, poison gas.

Breathing carbon monoxide can cause nausea, fainting or death.

•Operate generator ONLY outdoors.

•Keep exhaust gas from entering a confined area through windows, doors, ventilation intakes or other openings.

•DO NOT operate generator inside any building or enclosure (even if doors or windows are open), including the generator compartment of a recreational vehicle (RV).

Figure 4 — Generator Clearance

Exhaust Port

8

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Call Generator Helpline Llame Línea Directa del Generador Starting WattsModel / Modelo Equipment Description Table of ContentsSafety Rules When Adding or Draining Fuel When Starting EquipmentWhen Operating Equipment When Transporting or Repairing EquipmentWhen Adjusting or Making Repairs to Your Generator When Testing for Engine SparkRocker Switch Circuit Breaker The 120/240 Volt Battery Float Charger Jack Use battery float chargerKnow Your Generator Volt AC, 20 Amp Duplex Receptacles May beAttach Handle to Unit AssemblyUnpacking the Generator When Adding Fuel Before Starting the EngineAdd Fuel Engine OilUsing the Generator Connecting to a Building’s Electrical SystemSystem Ground Generator LocationOperating Generator Starting the EngineConnecting Electrical Loads How to Use the Battery ChargerStopping the Engine Do not Overload GENERATOR. See Don’t Overload GeneratorVolt AC, 20 Amp, Duplex Receptacle Receptacles120/240 Volt AC, 30 Amp, Locking Receptacle Power Management DON’T Overload GeneratorCapacity ExampleSpecifications General Maintenance RecommendationsEngine Maintenance Damaged or defective generatorStorage Troubleshooting Problem Cause CorrectionPage Limited Warranty Tabla DE Contenidos Descripción DEL EquipoReglas DE Seguridad AdvertenciaCuando Añada Combustible O Vacíe EL Depósito Cuando Ponga EN Funcionamiento EL EquipoCuando Opere EL Equipo Cuando Transporte O Repare EL EquipoCuando Pruebe LA Bujía DEL Motor PrecauciónCuando Ajuste O Haga Reparaciones a SU Generador Conozca SU Generador Culatazo el Principio Usó para comenzar motorConecte el Manubrio MontajeDesembalaje del Generador Antes DE Darle Arranque AL Motor Aceite de MotorAgregue Combustible Consideraciones Sobre el AceiteUSO DEL Generador Tierra del SistemaUbicación del Generador Conexión al Sistema Eléctrico de un EdificioOperando EL Generador Encienda el MotorConexion De Cargas Electricas Parado Del MotorCómo al Uso el Corcel de Batería No Sobrecargue GENERADOR. Vea No Sobrecargue GeneradorVolt AC, 20 Amperios, Receptáculos Dobles Receptáculos Precaución120/240 Voltios AC, 30 Amperios, Receptáculo de Seguridad No Sobrecargue Generador CapacidadControl de la Energía EjemploEspecificaciones Recomendaciones Generales DE MantenimientoMantenimiento del Motor Opere un generador que esté dañado o defectuosoAlmacenamiento Problemo Causa Accion Diagnositicos DE AveríasUso del consumidor Uso comercial

30205 specifications

Briggs & Stratton 30205 is a powerful and versatile portable generator that combines reliability with advanced technology, making it an excellent choice for home use, outdoor activities, or emergency power supply. Designed to deliver consistent performance, the 30205 model is equipped with a host of features that cater to both casual users and those who require a dependable power source during outages.

One of the standout features of the Briggs & Stratton 30205 is its sturdy 306cc engine, which is engineered for efficient fuel consumption and reduced emissions. This gasoline-powered engine generates an impressive 3,500 watts of starting power and 3,000 watts of running power, ensuring that it can handle a variety of applications, from powering appliances to running tools on the job site.

Durability is a hallmark of Briggs & Stratton products, and the 30205 does not disappoint. It features a rugged steel frame that provides protection against physical damage while enhancing stability during operation. The compact and portable design, complemented by durable wheels, allows for easy transport, making it a popular choice for camping trips or tailgate parties.

Technologically, the 30205 is equipped with an intuitive control panel that includes multiple outlet options, allowing users to connect different devices simultaneously. This generator includes both 120V and 120/240V outlets, providing flexibility for various power needs. Additionally, it incorporates a low oil shutdown feature to protect the engine from damage, automatically turning the generator off when oil levels are critically low.

For ease of use, the Briggs & Stratton 30205 also boasts a recoil start mechanism that ensures reliable operation regardless of conditions. Maintenance is made simple with easily accessible components, so users can keep the generator in peak condition with minimal effort.

In conclusion, the Briggs & Stratton 30205 represents a well-rounded solution for anyone in need of portable power. With its robust engine, durability, and user-friendly features, it stands out as a reliable option for both everyday use and emergencies. Whether for home back-up power or outdoor adventures, the 30205 generator is a practical investment for peace of mind.
Top Page Image Contents