MTD Troy-Bilt warranty Safe Operation Practices, Training, Preparation, Your Responsibility

Page 4

2

Safe

Operation

WARNING: Engine Exhaust, some of its constituents, and certain vehicle compo- nents contain or emit chemicals known to State of California to cause cancer and birth defects or other reproductive harm.

DANGER: This machine was built to be operated according to the safe operation practices in this manual. As with any type of power equipment, carelessness or error on the part of the operator can result in serious injury. This machine is capable of amputating hands and feet and throwing objects. Failure to observe the following safety instructions could result in serious injury or death.

Practices

WARNING

This symbol points out important safety instructions which, if not followed, could endanger the per- sonal safety and/or property of yourself and others. Read and follow all instructions in this manual before attempting to operate this machine. Failure to comply with these instructions may result in personal injury. When you see this symbol, HEED

ITS WARNING!

Your Responsibility

Restrict the use

of this power machine to persons who read, understand

and follow the warnings and instructions

in this manual

and on the machine.

Training

1.Read, understand, and follow all instructions on the machine and in the manual(s) before attempting to assemble and operate. Keep this manual in a safe place for future and regular reference and for ordering replacement parts.

2.Be familiar with all controls and their proper operation. Know how to stop the machine and disengage them quickly.

3.Never allow children under 14 years old to operate this machine. Children 14 years old and over should read and understand the instructions and safe operation practices in this manual and on the machine and be trained and supervised by an adult.

4.Never allow adults to operate this machine without proper instruction.

5.Thrown objects can cause serious personal injury. Plan your snow-throwing pattern to avoid discharge of material toward roads, bystanders and the like.

6.Keep bystanders, helpers, pets and children at least 75 feet from the machine while it is in operation. Stop machine if anyone enters the area.

7.Exercise caution to avoid slipping or falling, especially when operating in reverse.

Preparation

Thoroughly inspect the area where the equipment is to be used. Remove all doormats, newspapers, sleds, boards, wires and other foreign objects, which could be tripped over or thrown by the auger/impeller.

1.Always wear safety glasses or eye shields during operation and while performing an adjustment or repair to protect your eyes. Thrown objects which ricochet can cause serious injury to the eyes.

2.Do not operate without wearing adequate winter outer gar- ments. Do not wear jewelry, long scarves or other loose clothing, which could become entangled in moving parts. Wear footwear which will improve footing on slippery surfaces.

3.Use a grounded three-wire extension cord and receptacle for all units with electric start engines.

4.Adjust collector housing height to clear gravel or crushed rock surfaces.

5.Disengage all control levers before starting the engine.

6.Never attempt to make any adjustments while engine is running, except where specifically recommended in the operator’s manual.

7.Let engine and machine adjust to outdoor temperature before starting to clear snow.

Safe Handling of Gasoline

To avoid personal injury or property damage use extreme care in handling gasoline. Gasoline is extremely flammable and the vapors are explosive. Serious personal injury can occur when gasoline is spilled on yourself or your clothes, which can ignite. Wash your skin and change clothes immediately.

a.Use only an approved gasoline container.

b.Extinguish all cigarettes, cigars, pipes and other sources of ignition.

c.Never fuel machine indoors.

d.Never remove gas cap or add fuel while the engine is hot or running.

e.Allow engine to cool at least two minutes before refuel- ing.

f.Never over fill fuel tank. Fill tank to no more than ½ inch below bottom of filler neck to provide space for fuel expansion.

g.Replace gasoline cap and tighten securely.

h.If gasoline is spilled, wipe it off the engine and equip- ment. Move machine to another area. Wait 5 minutes before starting the engine.

i.Never store the machine or fuel container inside where there is an open flame, spark or pilot light (e.g. furnace, water heater, space heater, clothes dryer etc.).

j.Allow machine to cool at least 5 minutes before storing

k.Never fill containers inside a vehicle or on a truck or trailer bed with a plastic liner. Always place containers on the ground away from your vehicle before filling.

l.If possible, remove gas-powered equipment from the truck or trailer and refuel it on the ground. If this is not possible, then refuel such equipment on a trailer with a portable container, rather than from a gasoline dispenser nozzle.

m.Keep the nozzle in contact with the rim of the fuel tank or container opening at all times until fueling is complete. Do not use a nozzle lock-open device.

4

Image 4
Contents Two-Stage Snow Thrower 769-04094 06/10/08Finding and Recording Model Number Table of ContentsCustomer Support Safety Symbols There are rotating blades insideDo not use the engine’s electric starter in the rain Your Responsibility Restrict the useSafe Operation Practices TrainingPreparation Your ResponsibilityMaintenance & Storage OperationDo not modify engine Average Useful LifeSetting Up Your Snow Thrower Alternator Lead Lamp Wire Final Adjustments Clean-Out ToolDrift Cutters If Equipped Check the adjustment of the auger control as follows Skid ShoesTire Pressure Pneumatic Tires Auger ControlOperating Your Snow Thrower Know Your Snow Thrower$26% #/.42 Gas & Oil Fill-Up Stopping The EngineTo Engage Drive To Engage AugersAlways observe safety rules when performing any maintenance Operating TipsGeneral Recommendations If possible, remove snow immediately after it fallsAdjustments MakingShift Rod Drive ControlChute Assembly Chute Bracket AdjustmentSee Figure Adjust skid shoes as follows Auger ControlLubrication Maintaining Your Snow ThrowerReplacing Belts Auger Belt Remove LoosenDrive Belt Pulley SlotUsing a 3/4 wrench, hold the hex shaft Changing Friction Wheel RubberSecure with the cupped washer and hex bolt removed earlier Friction WheelOff-Season Storage Trouble Shooting Problem Cause RemedyWarranty 12.08.06For parts and/or accessories refer to customer support on Styles K & L 4554 428Parts List Pièces Détachées Adressez-vous au «Service après-vente»305-342 cc Torque to 21 ft./lbs. maximum618-04514 Worm Gear Box Ass’y w/ grease fitting With or without grease fittings Carter d’engrenages moitié CG avec raccord graisseFor parts and/or accessories refer to customer support on 100 101 100Part RÉF Pièce Description 29.08 Description Roue Jante Roulement Soupape dairFor parts and/or accessories refer to customer support on Page Garantie Garantie la annuleLubrification de et ’entretien conseilsSolution Causes Problème DépannagePropre UseAccompagne qui moteur du d’utilisation notice la dans Jours, 30 de plus pendant entreposé être doit moteur le SiFrottement de Roue Entretien’essieu de Et commandes les Poulie la De FenteMoteur du Tout empêcher pour’enlevez ÉloignezBoulon l’autre retirez Lubrification RouesVitesse de ment ’engrenageRéglages Des l’entraînement de Commande Vitesses de levier du Tige’essieu Support deGénéral d’ordre Recommandations ’utilisation ConseilsToucher Les de Évitez .65C 150F dépasserFaites Ne ’huile et d’essence PleinsGoulotte la de dégagement de Outil Roues des d’orientation Commande Goulotte la de CommandeGoulotte la de direction Fonctions 2 àSouffleuse la de Commandes Tiques pneuma Bandages pneus des Pression Support le sur679-390 OEM Modèles les Tous Souffleuse de ModèleGoulotte la de dégagement de Outil Pièce CetteLa Voir .«Réglages» chapitre le Consultez .goulotte la de Dents les avec bien s’engrène manivelle la de hélicoïdalePartie la que manière de ajusté être peut goulotte la de Manivelle la de support le est, besoin Si RemarqueGoulotte la de Installation Goulotte la de manivelle la de MontageGuidon du Montage ’assemblage pour requis ArticlesRemisage et Entretien Responsabilité VotreMoyenne utile vie de Durée Gaz de émissions les concernant AvisPréparation FormationVotre MentSécurité de Symboles Machine la d’utiliserVente-après Service Modèle de numéro le trouver PourMatières des Table ’utilisation La voir détachées PiècesCa.troybilt.www Phases deux neige à Souffleuse06/10/08