MTD 769-03247 warranty Safe Operation, Practices, Training, Preparation, Its Warning

Page 4
Safe

2

Safe

Operation

WARNING: Engine Exhaust, some of its constituents, and certain vehicle compo- nents contain or emit chemicals known to State of California to cause cancer and birth defects or other reproductive harm.

DANGER: This machine was built to be operated according to the safe operation practices in this manual. As with any type of power equipment, carelessness or error on the part of the operator can result in serious injury. This machine is capable of amputating hands and feet and throwing objects. Failure to observe the following safety instructions could result in serious injury or death.

Practices

WARNING

This symbol points out important safety instructions which, if not followed, could endanger the per- sonal safety and/or property of yourself and others. Read and follow all instructions in this manual before attempting to operate this machine. Failure to comply with these instructions may result in personal injury. When you see this symbol, HEED

ITS WARNING!

Your Responsibility

Restrict the use

of this power machine to persons who read, understand

and follow the warnings and instructions

in this manual

and on the machine.

Training

1.Read, understand, and follow all instructions on the machine and in the manual(s) before attempting to assemble and operate. Keep this manual in a safe place for future and regular reference and for ordering replacement parts.

2.Be familiar with all controls and their proper operation. Know how to stop the machine and disengage them quickly.

3.Never allow children under 14 years old to operate this machine. Children 14 years old and over should read and understand the instructions and safe operation practices in this manual and on the machine and be trained and supervised by an adult.

4.Never allow adults to operate this machine without proper instruction.

5.Thrown objects can cause serious personal injury. Plan your snow-throwing pattern to avoid discharge of material toward roads, bystanders and the like.

6.Keep bystanders, helpers, pets and children at least 75 feet from the machine while it is in operation. Stop machine if anyone enters the area.

7.Exercise caution to avoid slipping or falling, especially when operating in reverse.

Preparation

1.Thoroughly inspect the area where the equipment is to be used. Remove all doormats, newspapers, sleds, boards, wires and other foreign objects, which could be tripped over or thrown by the auger/impeller.

2.Always wear safety glasses or eye shields during operation and while performing an adjustment or repair to protect your eyes. Thrown objects which ricochet can cause serious injury to the eyes.

3.Do not operate without wearing adequate winter outer gar- ments. Do not wear jewelry, long scarves or other loose clothing, which could become entangled in moving parts. Wear footwear which will improve footing on slippery surfaces.

4.Use a grounded three-wire extension cord and receptacle for all units with electric start engines.

5.Adjust collector housing height to clear gravel or crushed rock surfaces.

6.Disengage all control levers before starting the engine.

7.Never attempt to make any adjustments while engine is running, except where specifically recommended in the operator’s manual.

8.Let engine and machine adjust to outdoor temperature before starting to clear snow.

Safe Handling of Gasoline

To avoid personal injury or property damage use extreme care in handling gasoline. Gasoline is extremely flammable and the vapors are explosive. Serious personal injury can occur when gasoline is spilled on yourself or your clothes, which can ignite. Wash your skin and change clothes immediately.

a.Use only an approved gasoline container.

b.Extinguish all cigarettes, cigars, pipes and other sources of ignition.

c.Never fuel machine indoors.

d.Never remove gas cap or add fuel while the engine is hot or running.

e.Allow engine to cool at least two minutes before refuel- ing.

f.Never over fill fuel tank. Fill tank to no more than ½ inch below bottom of filler neck to provide space for fuel expansion.

g.Replace gasoline cap and tighten securely.

h.If gasoline is spilled, wipe it off the engine and equip- ment. Move machine to another area. Wait 5 minutes before starting the engine.

i.Never store the machine or fuel container inside where there is an open flame, spark or pilot light (e.g. furnace, water heater, space heater, clothes dryer etc.).

j.Allow machine to cool at least 5 minutes before storing.

Image 4
Contents READ SAFETY RULES AND INSTRUCTIONS OPERATOR’S MANUALTwo-Stage Snow Thrower CAREFULLY BEFORE OPERATING EQUIPMENTFinding and Recording Model Number Table of ContentsCustomer Support Safety Labels result in personal injury. When you see this symbol, HEEDin this manual and on the machine ITS WARNING Your Responsibility Restrict the useSafe Operation PracticesTraining PreparationMaintenance & Storage Safe Operation PracticesOperation Do not modify engineSetting Up Your Snow Thrower Items Required For AssemblyBefore Assembly Loose PartsAttaching the Chute Assembly Clean-Out Tool Final AdjustmentsClean-Out Tool Drift Cutters If EquippedSkid Shoes Tire Pressure Pneumatic TiresOperating Your Snow Thrower Know Your Snow ThrowerR R1 Shift LeverChute Clean-Out Tool Drive Control / Auger Control LockTwo-Way Chute Control Ignition KeyGas & Oil Fill-Up Starting The EngineElectric Starter on certain models If you have a grounded three-prong receptacle, proceed as followsTo Engage Drive To Engage AugersOperating Tips General RecommendationsAdjustments MakingSee Figure Adjust skid shoes as follows 2. Raise or lower the skid shoe to desired position3. Retighten the hex nuts loosened earlier 4. Repeat on the other side of the snow throwerMaintaining Your Snow Thrower Drive and Shifting MechanismEngine WheelsReplacing Belts Auger BeltDrive Belt B C AFriction Wheel Assembly friction wheel assembly and hold assembly in positionChanging Friction Wheel Rubber Remove hex screw and washer Hex ShaftOff-Season Storage Trouble Shooting ProblemCause RemedyWarranty FOUR YEAR SUPREME WARRANTYAdressez-vous au «Service après-vente» For parts and/or accessories refer to customer support on pageà la page 2 pour ce qui concerne les pièces et/ou accessoires 9 23 Parts List Pièces détachées à la page 2 pour ce qui concerne les pièces et/ou accessoiresPART N DE85 Torque to 20-30 in./lbs Serrez à un couple14 de 20-30 po-lb49 légèrement au-dessus du goudron 24 Réglez-la au maximum en cas dallées gravillonnéesParts List Pièces détachées PART N DEDESCRIPTION PIÈCEAdressez-vous au «Service après-vente» B 43 536863 100 Tec PART N DEDESCRIPTION PIÈCEPART N DEDESCRIPTION PIÈCEAdressez-vous au «Service après-vente» 2 page on support customer to refer accessories and/or parts For Garantie ANS QUATRE DE SUPRÊME GARANTIEfrottement Solution DépannageCauses ProblèmeAVERTISSEMENT saison hors Remisageà carburant le Videz gaz d’entretien Régime 34 Figure33 Figure 3 Figured’entraînement Courroie 30 Figurecourroies les de Remplacement ÉloignezRoues vitesse de mentMoteur patins et LameRéglages plate lame la etsol le entre maximal ment 19 Figured’essieu support deOuverture 16 Figuresouffleuse la de Utilisation AVERTISSEMENTtarières les embrayer Pour transmission la embrayer Pourd’huile et d’essence Pleins électrique démarreur le d’utiliseravant instructions les toutes sement soigneu Suivez .conducteur le blessertarière la de commande la de /Blocage l’entraînement de Commande goulotte la dégagerde d’essayer avant immobilisées soient se pièces les toutes que ce jusqu’àsouffleuse la de Commandes moteur de Commandes14 Figure R1 Rmontage de Instructions tiquespneuma Bandages pneus des Pression 13 Figuremontage de InstructionsAVERTISSEMENT main la à goulotte la dansmontage de Instructions 3 Figure 2 Figure 1 Figure goulotte la de manivelle la de Montageguidon du Montage l’assemblage Avantsécurité de Consignes Remisage et EntretienSYMBOLE! CE ACCOMPAGNE QUI L’AVERTISSEMENT RESPECTEZ moyenne utile vie de Duréesécurité de ConsignesUtilisation Préparationsécurité de Étiquettes est goulotte la de dégagement de outil Unmodèle de numéro le trouver Pour vente-après Servicematières des Table phases deux à neige à Souffleuses D’UTILISATION NOTICE