Chute Assembly (all models)
1.Apply a light lubricant (i.e.
2.Place the chute assembly on the lip of the chute adapter. See Figure 3
3.One end of each chute keeper is already attached to the chute flange. Pivot the free end of the chute keeper to align it with the chute flange and push it till it snaps into position. See Figure 4. Repeat with remaining chute keepers.
Chute
Assembly
21
Figure 3
Chute
Assembly
3
Chute Keeper
Figure 4
For Models with 4 Way Chute Control Box
1.Pull the hairpin clip out of the clevis pin on the chute support tube. Save this hardware.
Hairpin Clip | 4 Way | |
Chute | ||
| ||
| Control | |
| Box | |
| Clevis | |
| Pin | |
| Chute Support | |
| Tube |
Figure 5
Cables
Short
Tube
Chute Support
Tube
Figure 6
2.Position the chute assembly so the chute opening is facing the front of the unit.
3.Place the chute control box on the short tube of the chute assembly and the chute support tube of the chute assembly as shown in Figure 6, cables should be towards the operator.
4.Insert the clevis pin, earlier removed, through the holes on the chute control box and chute support tube. Secure with the hairpin clip. See Figure 5.
For Models with 2Way Chute Control
1.Slip the cables, running from the chute to the handle panel into the cable guide located on top of the engine. See Figure 7 .
Cable Guide
Figure 7
Models with a Chute Directional Control
1.Remove the flat washer and hairpin clip from the end of the chute directional control. Insert the end of the chute directional control into the lower bracket and secure with the flat washer and hairpin clip just removed. See Figure 8.
NOTE: If necessary, the lower bracket can be adjusted. Refer to Chute Bracket Adjustment. in the Adjustment Section.
6