Sears 247.88852 owner manual Trouble-Shooting, Possible Causes, Corrective Action

Page 26
TROUBLE-SHOOTING

TROUBLE-SHOOTING

Trouble

Possible Cause(s)

Corrective Action

 

 

 

Engine fails to start

Fuel tank empty, or stale fuel.

Fill tank with clean, fresh gasoline. Fuel will not last over thirty

 

 

days unless a fuel stabilizer is used.

 

Blocked fuel line.

Clean fuel line.

 

Choke not in ON position

Move switch to ON position

 

Faulty spark plug.

Clean, adjust gap or replace.

 

Key not in switch on engine.

Insert key.

 

Spark plug wire

Connect spark plug wire.

 

disconnected.

 

 

Primer button not depressed.

Refer to the engine manual packed with your unit.

 

Fuel shut-off valve closed

Open fuel shut-off valve.

 

(if so equipped).

 

 

Throttle in Stop position

Move Throttle to RUN position.

Engine runs erratic

Unit running on CHOKE.

Move choke lever to OFF position.

 

Blocked fuel line or stale fuel.

Clean fuel line; fill tank with clean fresh gasoline. Fuel will not last

 

 

over thirty days unless a fuel stabilizer is used.

 

Water or dirt in fuel system.

Drain fuel tank. Refill with fresh fuel.

 

Carburetor out of adjustment.

Refer to the engine manual packed with your unit or have

 

 

carburetor adjusted by an authorized service dealer.

Loss of power

Spark plug wire loose.

Connect and tighten spark plug wire.

 

Gas cap vent hole plugged.

Remove ice and snow from cap. Be certain vent hole is clear.

 

Exhaust port plugged.

Clean-see Maintenance section of engine manual.

Engine overheats

Carburetor not adjusted

Refer to the engine manual packed with your unit or have

 

properly.

carburetor adjusted by an authorized service dealer.

Excessive vibration

Loose parts or damaged

Stop engine immediately and disconnect spark plug wire. Tighten

 

auger.

all bolts and nuts. Make all necessary repairs. If vibration

 

 

continues, have unit serviced by an authorized service dealer.

Unit fails to propel

Incorrect adjustment of drive

Adjust drive cable. Refer to Adjustment section of this manual.

itself

cable.

Replace drive belt. Refer to Belt Replacement in Maintenance

 

Drive belt loose or damaged.

section of this manual.

 

Rubber on friction wheel worn

Replace rubber following instructions on page 23.

 

off

 

Unit fails to

Discharge chute clogged.

Stop engine immediately and disconnect spark plug wire. Clean

discharge snow

 

discharge chute and inside of auger housing.

 

Foreign object lodged in

Stop engine immediately and disconnect spark plug wire.

 

auger.

Remove object from auger.

 

Incorrect adjustment of drive

Adjust drive cable. Refer to Adjustment section of this manual.

 

cable.

Replace drive belt. Refer to Belt Replacement in Maintenance

 

Drive belt loose or damaged.

section of this manual.

For repairs beyond the minor adjustments listed above, please contact your nearest SEARS service center.

26

Page 25 Page 27
Image 26
Page 25 Page 27
Contents 247.888520 Owner’s ManualSnow Thrower 9 Horse Power 26” Two-Stage Wheel DrivePRODUCT SPECIFICATIONS TABLE OF CONTENTSWARRANTY INFORMATION ContentTRAINING SAFE OPERATION PRACTICESSAFETY PREPARATIONMAINTENANCE AND STORAGE YOUR RESPONSIBILITYHARDWARE PACK Removing From Carton ASSEMBLYAttaching Handle Assembly Loose PartsAttaching Chute Crank ASSEMBLYAttaching Chute Crank Bracket Attaching Clutch CablesLower Chute Hex Lock NutAttaching Shift Rod Attaching Turn TriggersTrigger Cable Lamp WiringFinal Adjustments Auger ControlTire Pressure Pneumatic Tires Skid Shoe Remove these hardware to adjust skid shoeSkid Shoe Knowing Your Snow Thrower OPERATIONMeets ANSI Safety Standards To Stop The Snow Thrower Safety Ignition SwitchOperating Controls Before Starting EngineA. Electric Starter To Start EngineStarting Instructions at a glance PushWarm Start Operating Snow ThrowerTo Throw Snow B. Recoil StarterTo avoid possible freeze-up of the starter, follow Operating TipsBefore Stopping Recoil StarterGeneral Recommendations MAINTENANCEMAINTENANCE Customer ResponsibilitiesViscosity Chart Engine MaintenanceFigure 19 Lubrication Chart LubricationChanging Oil Spark PlugChute Assembly SERVICE & ADJUSTMENTSAdjustments Traction Drive ClutchCarburetor ServiceADJUSTMENTS AugersNOTE Make sure that the auger cable is routed in front of the belt PUSHNOTE Use care to avoid pinching the control cable Drive BeltChanging Friction Wheel Rubber CoverCarburetor Note If you placed plastic under the gas cap, be certain to remove itPreparing Snow Thrower OFF-SEASON STORAGEPreparing Engine STORAGEPossible Causes TROUBLE-SHOOTINGTrouble Corrective ActionSpark Plug ACCESSORIESBelt Shave Plate REPAIR PARTS SEARS CRAFTSMAN 9.0 H.P. SNOW THROWER MODELPARTS LIST Drive Clutch Cable routed below axle and hooked here SEARS CRAFTSMAN 9.0 H.P. SNOW THROWER MODEL NOTE For painted parts, please refer to the list of Handle Support Bracket L.H. 5/8 Includes references 58 throughHex B-Tapp Screw # 10-16 x Handle Support Bracket R.H. 5/8SEARS CRAFTSMAN 9.0 H.P. SNOW THROWER MODEL SEARS CRAFTSMAN 9.0 H.P. SNOW THROWER MODEL Page Table continued on next page Craftsman Engine Model No. 143.999005 for CraftsmanSnow Thrower Model Recoil Starter CARBURETOR Page Page Page 7084-659-800 1 semana la a días 7 pm, 7 a am 7 de Llame domicilio, a entrega con piezas ordenar Paradomicilio, a reparación de servicio pedir Para 5811-676-800 1 semana la a días 7 día, al horas 24 Llamecorrectora Accion DE LOCALIZACION DE TABLAProblema posible Causasmotor del Preparación TEMPORAIENALMNADECNieve de Expulsor del Preparación usa si carburador el drene No .carburador al llegue34 Figura colocadohaberlo de gasolina, de tapa la de debajo colocado 33 Figurala simétricamente ensamblar importante Es NOTA apropiadofuncionamiento un para fricción de rueda la en goma 32 Figuracontrol propulsora Correacorrea la de frente al encaminado esté de cable el apretar evitar para precavido Sea NOTA23 Figura Service25 Figura 24 FiguraCanaleta La De Conjunto AJUSTES & SERVICEAjustes 21 Figuracomercial Motor del Mantenimiento20 Figura solvente un con lavando y alambre de cepillocliente del Responsabilidades MANTENIMIENCambios De Mecanismo LubricacionArranque de Abreviadas Instrucciones Ruedas La De PresionOperacion De Consejos operación su con familiarizarseMotor El Apagar Como sin cambios de palanca la mueva NUNCA NOTAPropulsor El Enganchar Para 18 Figuraeléctrico Arrancador Motor Del ArranqueAceite Y Gasolina De Llenado Nieve De Expulsor Del DetencionNieve De Expulsor Su Conozca OPERACIONCambios De Palanca Gatillo Del PalancaAjustes de sección la a refiérase detalles, más Para NOTA 16 FiguraDeslizante Zapata la de Ajuste desconectada está bujía la que asegurarseLámpara la de Cableado transmisión la de cambiosFinales Ajustes 15 FiguraGiro De Gatillos Los De Fijacion Cambios De Vara La De Fijaciony velocidad sexta de posición la de fuera cambios Embrague Del Cables Los De Fijacion7 Figura 9 Figura8 Figura 6 Figura3 Figura Canaleta La De FijacionCanaleta La De Manivela La De Fijacion 4 FiguraRequeridas Herramientas ENSAMBLADOMango Del Conjunto Del Fijacion Sueltas PiezasFERRETERIA DE FERRETERIA DE CONJUNTO tiempos dos de Aceite NIEVE DE EXPULSOR DEL ACCESORIOSBujía raspadora Barra gasolina de Recipiénte CorreaSears nieve de expulsor su de segura operación PREPARACION OPERACION DE SEGURAS PRACTICASOPERACION ENTRENAMIENTOProducto Del Especificaciones INFORMACIÓN DE GARANTIACONTENIDO DE TABLA USA 60179 IL Estates, Hoffman ,.Co And Roebuck Sears Propietario Del ManualFUERZA DE CABALLOS NIEVE DE EXPULSOR 888520.247 Modelo De .No
Top Page Image Contents