Craftsman 536.88644 manual Espanol, Wash Hands After Handling

Page 2

WARRANTY STATEMENT

2

STORAGE

28

SAFETY

RULES

...............

2

TROUBLE SHOOTING CHART .. 29

INTERNATIONAL

SYMBOLS ....

4

REPAIR

PARTS

30

ASSEMBLY

 

6

ENGINE

REPAIR PARTS

....... 46

OPERATION

11

SPANISH

(ESPANOL)

55

MAINTENANCE

...............

17

PARTS ORDERING/SERVICE.,

SERVICE

AND

ADJUSTMENT ..

20

 

 

BACK COVER

LIMITED "13NO--YEARWARRANTY ON CRAFTSMAN SNOW THROWER

For two years from the date of purchase, when this Craftsman Snow thrower is maintained, lubricated, and tuned up according to the operating and maintenance instructions in the owner's manual, Craftsman will repair, free of charge, any defect in material or workman- ship.

If this Craftsman Snow thrower is used for commercial or rental purposes, this warranty ap- plies for only 90 days from the date of purchase.

This warranty does not cover the following:

Items which become worn during normal use, such as spark plugs, drive belts and shear pil_s.

Repair necessary because of operator abuse or negligence, including bent crankshafts

and the failure to maintain the equipment according to the instructions contained in the owner's manual.

WARRANTY SERVICE IS AVAILABLE BY RETURNING THE CRAFTSMAN SNOW

THROWERTO THE NEAREST CRAFTSMAN SERVICE CENTER/DEPARTMENT IN THE UNITED STATES. THIS WARRANTY APPLIES ONLY WHILE THIS PRODUCT IS IN USE IN THE UNITED STATES.

This warranty gives you specific legal rights, and you may also have other rights which may vary from state to state.

Sears, Roebuck and Co., D817WA, Hoffman Estates. IL 60179

LOOK FOR THIS SYMBOL TO POINT OUT IMPORTANT SAFETY PRECAUTIONS. IT MEANS-- ATrENTION!!! BECOME ALERT!!! YOUR SAFETY IS INVOLVED.

Engine Exhaust, some of its constituents, and

certain vehicle components contain or emit chemicals known to the State of California to

cause cancer and birth defects or other repro- ductive harm.

Battery posts, terminals and related accessories contain lead and lead compounds, chemicals known to the State of California to cause cancer

and birth defects or other reproductive harm.

WASH HANDS AFTER HANDLING.

nect the spark plug wire

,_ WARNING: Always discon- and place it where it cannot

make contact with spark plug to prevent accidental starting during: Preparation, Maintenance, or Stor- age of your snow thrower.

IMPORTANT: Safety standards re- quire operator presence controls to minimize the risk of injury. Your snow thrower is equipped with such controls. Do not attempt to defeat the function of

the operator presence control under any circumstances.

F-001087J

2

Image 2 Contents
Icrrftsmrni 001087JEspanol Wash Hands After HandlingTraining PreparationMaintenance and Storage Do not attempt to use snow thrower on a roofSafetyWarningSymbols 4-20 SplitLockwasher11/32 To Remove Snow Thrower From Carton Tools Required for AssemblyThrower Remove from the carton Place until needed for storageLoosen, but do not To Assemble the Handle and Crank AssemblyCaught between the upper and lower handle Universal To Install Shifter KnobPin. Spread ends of cotter pin to DriveHOW to SET the Skid Height Snow Chute AssemblyChecklist Service And Adjustment sectionKnow Your Snow Thrower Choke Control Used to start a coldTo USE Wheel Lockout PIN HOW to Move Forward and BackwardTo Stop Your Snow Thrower To Control Snow DischargeDicates that alcohol blended Before Starting the EngineFill GAS Electric starter, if equipped To Stop EngineTo Start Engine Cold StartEngine runs smoothly, move choke lever to No Choke Position Do not prime if temperature above 50 F 10 CWarm Start Frozen StarterSnow Throwing Tips 001087J16General Recommendations Lubrication ChartCustomer Responsibilities After Each USELUBRICATION-EVERY 25 Hours Product SpecificationsAS Required Wheel and disc drive plateSpark Plug LubricationTo Change Engine OIL 001087J19To Adjust Skid Height To Adjust Scraper BARDrive Lever HOW to Check and Adjust CablesTo Adjust Belts Traction Drive Belt How To Remove The Auger Drive BeltTo Replace Belts Side/ %Belt Outdoors, away from fire orTraction Drive Belt AugerHow To Check The Friction Wheel HOW to Adjust or Replace the Friction WheelHOW to Adjust the Belt Guide Remove Top Bolt each sideHow To Replace The Friction Wheel To Adjust or Replace the Spark Plug HOW to Replace the Auger Shear BoltTo Adjust the Carburetor To adjustTo Replace Other Thoroughly clean the snow throwerEngine Provide maximum performance for the next seasonDifficult starting CauseTrouble CorrectionWasher Frame AssemblyScrew 001087J30Electric Start Assembly Motor StarterCOVER, Bottom Idler AssemblyFrame Assy SEAL, OIL Gear Case AssemblyCase Gear Bearing217 Drive Components190 191 255247 245246 249Auger Housing Assembly 5OO48O PULLEY, 4L 6.12X 9517 711862 9357 301380-853 340720 710026 760875Discharge Chute Assembly CraftsmanWasher Plastic Handle Assembly OO1087J4073O 756Wheel Assembly 671 655 650 678Shift Yoke Assembly 791 792 8812866 Chute Control ROD Assembly867 Model Plate Decal Drive Clutch SymbolDecal Auger Clutch Symbol Decal Chute HandCraftsman 4-CYCLE Engine Model Number KEY Part NO. no KEY Part Description RPM650139 27677ALill Ill KEY PartIOA Spring Retainer 33290E Electric Starter VoltRetainer Ring Anti-drift SpringOO1087J52 KEY Part Description Part Idhhhh