Craftsman 247.8879 manual This page applicable in the U.S.A. and Canada only

Page 33

(This page applicable in the U.S.A. and Canada only.)

Sears, Roebuck and Co., U.S.A. (Sears), the California Air Resources Board (CARB)

and the United States Environmental Protection Agency (U.S. EPA)

Emission Control System Warranty Statement (Owner’s Defect Warranty Rights and Obligations)

EMISSION CONTROL WARRANTY COVERAGE IS APPLICABLE TO CERTI- FIED ENGINES PURCHASED IN CALIFORNIA IN 1995 AND THEREAF- TER, WHICH ARE USED IN CALIFORNIA, AND TO CERTIFIED MODEL

YEAR 1997 AND LATER ENGINES WHICH ARE PURCHASED AND USED ELSEWHERE IN THE UNITED STATES (AND AFTER JANUARY 1, 2001 IN CANADA).

California and United States Emission Control Defects Warranty Statement

The California Air Resources Board (CARB), U.S. EPA and Sears are pleased to explain the Emission Control System Warranty on your model year 2000 and later small off-road engine (SORE). In California, new small off-road engines must be designed, built and equipped to meet the State’s stringent anti-smog standards. Elsewhere in the United States, new non-road, spark-ignition engines certified for model year 1997 and later must meet similar standards set forth by the U.S. EPA. Sears must warrant the emission control system on your

engine for the periods of time listed below, provided there has been no abuse, neglect or improper maintenance of your small off-road engine.Your emis- sion control system includes parts such as the carburetor, air cleaner, ignition system, muffler and catalytic converter. Also included may be connectors and other emission related assemblies. Where a warrantable condition exists, Sears will repair your small off-road engine at no cost to you including diagnosis, parts and labor.

Sears Emission Control Defects Warranty Coverage

Small off-road engines are warranted relative to emission control parts defects

part on your engine is defective, the part will be repaired or replaced by Sears.

for a period of one year, subject to provisions set forth below. If any covered

 

Owner’s Warranty Responsibilities

As the small off-road engine owner, you are responsible for the performance of the required maintenance listed in your Operating and Maintenance Instruc- tions. Sears recommends that you retain all your receipts covering maintenance on your small off-road engine, but Sears cannot deny warranty solely for the lack of receipts or for your failure to ensure the performance of all scheduled maintenance. As the small off-road engine owner, you should however be aware that Sears may deny you warranty coverage if your small off-road engine or a part has failed due to abuse, neglect, improper maintenance or unap-

proved modifications.You are responsible for presenting your small off-road engine to an Authorized Sears Service Dealer as soon as a problem exists. The undisputed warranty repairs should be completed in a reasonable amount of time, not to exceed 30 days.If you have any questions regarding your warranty rights and responsibilities, you should contact a Sears Service Representative at 1--800--469--4663. The emission warranty is a defects warranty. Defects are judged on normal engine performance. The warranty is not related to an in-use emission test.

Sears Emission Control Defects Warranty Provisions

The following are specific provisions relative to your Emission Control Defects Warranty Coverage. It is in addition to the Sears engine warranty for non-regulated engines found in the Operating and Maintenance Instructions.

1.

Warranted Parts

3.

No Charge

 

Coverage under this warranty extends only to the parts listed below (the

 

Repair or replacement of any Warranted Part will be performed at no

 

emission control systems parts) to the extent these parts were present on

 

charge to the owner, including diagnostic labor which leads to the

 

the engine purchased.

 

determination that a Warranted Part is defective, if the diagnostic work is

 

a.

Fuel Metering System

 

performed at an Authorized Sears Service Dealer. For emissions warranty

 

 

• Cold start enrichment system

 

service contact your nearest Authorized Sears Service Dealer as listed in

 

 

• Carburetor and internal parts

 

the “Yellow Pages” under “Engines, Gasoline,” “Gasoline Engines,” “Lawn

 

 

• Fuel Pump

 

Mowers,” or similar category.

 

 

4. Claims and Coverage Exclusions

 

b.

Air Induction System

 

 

Warranty claims shall be filed in accordance with the provisions of the

 

 

• Air cleaner

 

 

 

 

Sears Engine Warranty Policy. Warranty coverage shall be excluded for

 

 

• Intake manifold

 

 

 

 

failures of Warranted Parts which are not original Sears parts or because

 

c.

Ignition System

 

 

 

of abuse, neglect or improper maintenance as set forth in the Sears

 

 

• Spark plug(s)

 

 

 

 

Engine Warranty Policy. Sears is not liable to cover failures of Warranted

 

 

• Magneto ignition system

 

 

 

 

Parts caused by the use of add-on, non-original, or modified parts.

 

d.

Catalyst System

 

 

5.

Maintenance

 

 

• Catalytic converter

 

 

 

Any Warranted Part which is not scheduled for replacement as required

 

 

• Exhaust manifold

 

 

 

 

maintenance or which is scheduled only for regular inspection to the effect

 

 

• Air injection system or pulse valve

 

 

 

 

of “repair or replace as necessary” shall be warranted as to defects for the

 

e.

Miscellaneous Items Used in Above Systems

 

 

 

warranty period. Any Warranted Part which is scheduled for replacement

 

 

• Vacuum, temperature, position, time sensitive valves

 

 

 

 

as required maintenance shall be warranted as to defects only for the

 

 

and switches

 

period of time up to the first scheduled replacement for that part. Any

 

 

• Connectors and assemblies

 

replacement part that is equivalent in performance and durability may

2.

Length of Coverage

 

be used in the performance of any maintenance or repairs. The owner is

 

Sears warrants to the initial owner and each subsequent purchaser that

 

responsible for the performance of all required maintenance, as defined in

 

the Warranted Parts shall be free from defects in materials and workman-

 

the Sears Operating and Maintenance Instructions.

 

ship which caused the failure of the Warranted Parts for a period of one

6.

Consequential Coverage

 

year from the date the engine is delivered to a retail purchaser.

 

Coverage hereunder shall extend to the failure of any engine components

 

 

 

 

caused by the failure of any Warranted Part still under warranty.

In the USA and Canada, a 24 hour hot line, 1-800-469-4663, has a menu of pre-recorded messages offering you engine maintenance information.

33

Image 33
Contents Operator’s Manual Warranty Statement Table of ContentsProduct Specifications Model NumberSafety Labels Your ResponsibilityChine Training Safe Operation PracticesDo not modify engine OperationRemoving From Carton AssemblyAssembly Auger Control Shear Pin StorageSkid Shoes Tire PressureOperation $26% #/.42 Gasoline OilElectric Starter Recoil StarterAuger Control Test Stopping The EngineMaintenance Check Chute Cables Changing OilCheck Spark Plug Check AugersService & Adjustments Replacing BeltsAuger Belt Friction Wheel Rubber Drive BeltAny adjustments while engine is running Shift CableChute Control Retighten nuts and bolts securely Drive ControlOFF-SEASON Storage Short-Term StorageLong-Term Storage Troubleshooting Parts List Description Craftsman 9 H.P. Snow Thrower ModelParts List 684-04112B 55 56 Auger Clutch Cable Guide Bracket Page Piston, Pin & Ring Set .010 OS incl SAE 5W30, 4-Cycle Engine Oil Quart 640349 590574 Mitten Grip Handle optional 35450 Ring 35915 Armature 35451B Housing Assembly 35452A Owner’s Warranty Responsibilities Sears Emission Control Defects Warranty CoverageSears Emission Control Defects Warranty Provisions This page applicable in the U.S.A. and Canada onlyPage Repair Protection Agreement Manual del operador Declaración DE Garantía ÍndiceEspecificaciones DEL ProductoEtiquetas DE Seguridad Limpiar el montaje del canaMáquina quitanieve Capacitación Prácticas DE Operación SegurasNo modifique el motor OperaciónAviso referido a emisiones Calcomanía de identificación del motorExcepción será especificado MontajeInferior Manija inferiorAlmacenamiento del pasador de cuchilla Herramienta de limpiezaPrueba de control de la barrena Ajustes finalesDe la barrena antes de operar su máquina Cada invierno. Si no respeta estas instrucControl de transmisión y palanca de cambios Zapata antideslizantePresión de los neumáticos Operación Para encender el motor Antes de encender el motorArranque en frío Arrancador de retrocesoArranque en caliente Arrancador de retroceso congeladoProcedimiento para quitar la nieve Antes de detener la máquinaProcedimiento para engranar la transmisión Procedimiento para engranar las barrenasMantenimiento Revise los cables del canal Cambio de aceiteControle la bujía Control de las barrerasServicio Y Ajustes Reemplazo de las correasCorrea de la barrena Correa de transmisión Goma de la rueda de fricciónCercano según las instrucciones de la página Cable de cambios Control del canalMiento Zapatas antideslizantes Control de la transmisiónAjuste, proceda de la siguiente manera Para ajustar el control de la barrena, consulte la páginaAlmacenamiento Fuera DE Temporada Problemas de encendidoDispositivo a gas AlmacenarlaSolución DE Problemas Piezas con garantía Esta página se aplica sólo en EE.UU. y CanadáAcuerdo DE Protección Para Reparaciones Notas Get it fixed, at your home or ours

247.8879 specifications

The Craftsman 247.8879 is a versatile and reliable snow thrower designed to tackle winter’s harshest conditions. This powerful machine has gained popularity among homeowners for its efficiency, ease of use, and robust build.

One of the main features of the Craftsman 247.8879 is its 24-inch clearing width. This allows users to clear large areas rapidly, making it ideal for driveways, sidewalks, and patios. The snow thrower is equipped with a 208cc engine, providing ample power to handle heavy, wet snow. This engine not only enhances performance but also ensures efficient fuel consumption, offering an excellent balance between power and economy.

Another standout characteristic of the Craftsman 247.8879 is the six-speed transmission, which includes four forward speeds and two reverse speeds. This feature enables users to maintain control while navigating various terrains and snow depths, making it adaptable to different conditions. The adjustable, polymer skid shoes further enhance the snow thrower’s performance, allowing for easy height adjustments to prevent damage to surfaces while ensuring a thorough clean.

The snow thrower also features a 180-degree rotating chute, which allows users to direct the snow where it needs to go quickly. Operators can easily adjust the chute direction with a simple lever, making it convenient to maneuver around obstacles and control where the snow is thrown. Additionally, the ergonomic handles provide comfort during operation, reducing fatigue during extended use.

Safety is a crucial aspect of the Craftsman 247.8879, which comes equipped with an electric start feature. This means that users can start the machine with the push of a button, eliminating the hassle of pulling a cord in cold weather. Furthermore, the snow thrower's design emphasizes stability and control, enhancing safety while in operation.

In terms of durability, the Craftsman 247.8879 boasts heavy-duty construction that can withstand the rigors of winter use. Materials used in the build are designed to resist wear and tear, ensuring longevity. With all these features combined, the Craftsman 247.8879 stands out as a reliable partner for tackling snowy conditions, making it a smart investment for homeowners looking to simplify their winter maintenance tasks.