OPERATING POSITION
(Figure 7)
To connect the brush attachment to traction unit:
1.Place attachment belts onto attachment pulley.
NOTE: Holding down the attachment clutch lever will make it easier to reconnect the brush attachment to traction unit.
2.Tip traction unit back while guiding brush attachment up and onto lower pivot rod.
3.Tilt traction unit back up level to bring it together with brush attachment.
4.Install cap screws (one on each side at top) to secure brush attachment to traction unit.
5.Place attachment drive belts onto engine sheave. It may be necessary to turn engine sheave using recoil starter handle (Figure 12).
6.Reinstall belt finger. Check belt finger clearance (See Check Belt Finger Clearance on page 22).
IMPORTANT: DO NOT bend belt finger out of shape.
7.Install bottom cover with six cap screws.
8.Install belt cover.
9.Reinstall remote trigger cable to brush assembly.
MAINTENANCE SCHEDULE
The chart below shows the recommended maintenance schedule that should be performed on a regular basis. More frequent service may be required due to working conditions (heavy loads, high ambient temperatures, dusty conditions, or airborne debris).
MAINTENANCE SCHEDULE
|
|
|
| Yearly |
Service | Each | Daily | Every | or |
Performed | Use | (8 hrs.) | 25 hrs | 100 |
|
|
|
| hrs |
|
|
|
|
|
Check Dual | • |
|
|
|
Handle |
|
|
| |
Interlock |
|
|
|
|
|
|
|
|
|
Check | • |
|
|
|
Fasteners |
|
|
| |
|
|
|
| |
|
|
|
|
|
Check | • |
|
|
|
Clutch |
|
|
| |
Operation |
|
|
|
|
|
|
|
|
|
Clean | • |
|
|
|
Engine |
|
|
| |
|
|
|
| |
|
|
|
|
|
Clean Recoil | • |
|
|
|
Guard Foam |
|
|
| |
Cover |
|
|
|
|
|
|
|
|
|
Check |
| • |
|
|
Engine Oil |
|
|
| |
|
|
|
| |
|
|
|
|
|
General |
| • |
|
|
Lubrication |
|
|
| |
|
|
|
| |
|
|
|
|
|
Check |
|
| *• |
|
Clutch Cable |
|
|
| |
Adjustments |
|
|
|
|
|
|
|
|
|
Check Tire |
|
| • |
|
Pressure |
|
|
| |
|
|
|
| |
|
|
|
|
|
Change |
|
|
|
|
Engine Oil** |
|
|
|
|
|
|
|
|
|
*After first 5 hours of operation.
**Refer to Engine Manual for detailed instructions.
CHECK DUAL HANDLE
INTERLOCK
Without the engine running, press down (engage) both clutch levers. Release attachment clutch lever. Attachment clutch should remain engaged until traction clutch lever is released, then both clutches must disengage.
CHECK FASTENERS
Make sure all hardware is tightened properly.
EN - 17