Ariens 926057 warranty Check Clutch Operation, Check Clutch Cable Adjustment, Clean Engine

Page 18

CHECK CLUTCH OPERATION

Brush must stop quickly when attachment clutch lever is released.

Wheels must stop quickly when traction drive clutch lever is released.

If clutches do not engage or disengage properly, adjust or repair before operation (seeAttachment Clutch Adjustment on page 21 and Traction Drive Clutch Adjustment on page 23).

CHECK CLUTCH CABLE

ADJUSTMENT

Make sure the attachment clutch and traction drive clutch are adjusted as specified in Attachment Clutch Adjustment on page 21 and Traction Drive Clutch Adjustment on page 23.

CLEAN ENGINE

Refer to Engine Manual for detailed instructions.

CLEAN RECOIL GUARD FOAM COVER

Make sure the recoil guard foam cover is always kept clean and free of snow and debris.

If cover becomes clogged with debris gently vacuum the foam or wash with warm water.

NOTE: Cover is not necessary for operation during the non-winter months.

If cover is clogged with snow remove it immediately and allow foam to thaw or rinse with warm water.

IMPORTANT: Allow foam to dry completely before reinstallation.

See Recoil Guard Foam Cover Installation on

page 20.

CHECK ENGINE OIL

The engine crankcase oil should be checked every 8 hours of operation. Oil level MUST be maintained in safe operating range on dipstick at all times or engine damage will result (See Engine Manual).

Park unit on a level surface. Refer to Engine Manual for detailed instructions.

CHANGE ENGINE OIL

Refer to Engine Manual for detailed instructions.

CHECK TIRE PRESSURE

CAUTION: Avoid injury! Explosive separation of tire and rim parts is possible when they are serviced incorrectly:

•Do not attempt to mount a tire without the proper equipment and experience to perform the job.

•Do not inflate the tires above the recommended pressure.

•Do not weld or heat a wheel and tire assembly. Heat can cause an increase in air pressure resulting in an explosion. Welding can structurally weaken or deform the wheel.

•Do not stand in front or over the tire assembly when inflating. Use a clip-on chuck and extension hose long enough to allow you to stand to one side.

Check tire pressure and adjust to the pressure listed on tire sidewall.

EN - 18

Page 17 Page 19
Image 18
Page 17 Page 19
Contents Power Brush Table of Contents IntroductionSafety Safety Decals Locations Required Operator TrainingSafety Rules Emission Control SystemPage Page Unpacking Unit Unfold Handlebar AssemblyTools Required Check Function of Dual Handle InterlockFill Engine Fuel Tank Check Tire PressureCheck Engine Crankcase Oil Check Function of all ControlsControls and Features Operation Standard ControlsBrush Angle Adjustment Brush Height AdjustmentFilling Fuel Tank Gasoline Add Fuel to Fuel TankPRE-START To Stop in AN EmergencyStarting and Shut OFF Using the Brush TravelingTransport Maintenance Service PositionOperating Position Maintenance ScheduleMaintenance Schedule Check Dual Handle InterlockClean Recoil Guard Foam Cover Check Clutch Cable AdjustmentClean Engine Check Clutch OperationGeneral Lubrication Service and Adjustments Recoil Guard Foam Cover InstallationSpeed Selector Adjustment Attachment Clutch Adjustment Remove Attachment Cable SlackCheck Attachment Idler Arm Roller Clearance Check Belt Finger ClearanceTraction Drive Clutch Adjustment Attachment Drive Belts ReplacementTraction Drive Belt Replacement Friction Disc Replacement Install both wheel/tiresBrush Segment Replacement Joint Long Term StorageShort Term Fuel SystemTroubleshooting Service PartsSpecifications EngineSpecial Extensions Exceptions and Limitations Limitation of Remedy and Damages Page Ariens Company West Ryan Street Brillion, WI Fax
Top Page Image Contents