Ariens 926057 warranty Joint

3.Loosen each bearing setscrew and slide bearings inward, away from horizontal end supports.

1 5

IMPORTANT: Brush gearbox splined shaft will separate from brush housing u-joint. Support splined shaft to prevent damage (Figure 19).

2

3

2

4

4

1

1. Brush Segment

2. U-Joint

3. Splined Shaft

4. Gearbox

Figure 19

4.Manually move traction unit backwards, pulling brush housing away from brush assembly.

NOTE: The gearbox at the center of the brush allows only half the brush segments to be removed from each end.

5.Stand brush assembly upright on one end.

6.Remove three flanged bolts securing end plate to support shaft assembly. Remove the end plate (Figure 20).

3

1.Flanged Bolts

2.Engagement Fingers

3.Support Shaft Assembly

4.Brush Segment

5.End Plate

Figure 20

EN - 26