Ariens 926057 warranty Check Tire Pressure, Check Engine Crankcase Oil, Fill Engine Fuel Tank

Page 9

Check Tire Pressure

Check tire pressure and adjust to the pressure listed on tire sidewall.

CAUTION: Avoid injury! Explosive separation of tire and rim parts is possible when they are serviced incorrectly:

•Do not attempt to mount a tire without the proper equipment and experience to perform the job.

•Do not inflate the tires above the recommended pressure.

•Do not weld or heat a wheel and tire assembly. Heat can cause an increase in air pressure resulting in an explosion. Welding can structurally weaken or deform the wheel.

•Do not stand in front or over the tire assembly when inflating. Use a clip-on chuck and extension hose long enough to allow you to stand to one side.

Check Engine Crankcase Oil

IMPORTANT: Engine is shipped with 5W-30oil in crankcase. Refer to Engine Manual for detailed instructions.

Fill Engine Fuel Tank

Refer to Engine Manual for proper fuel type and tank capacity. Refer to FILLING FUEL TANK on page 13.

Check Function of all Controls

Ensure unit runs and performs properly. Refer to Operation on page 11.

Run-in Attachment Belt

1.Start unit in a well-ventilated area according to Starting and Shut Off on page 14.

2.Engage attachment clutch lever and run attachment for about 15 minutes.

3.Stop unit, wait for all moving parts to stop, and remove spark plug wire.

4.Adjust clutch idler according to Attachment Clutch Adjustment on page 21.

5.Adjust belt finger, if necessary. See Check Belt Finger Clearance on page 22.

EN - 9

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Power Brush Introduction Table of ContentsSafety Required Operator Training Safety Decals LocationsEmission Control System Safety RulesPage Page Tools Required AssemblyUnpacking Unit Unfold Handlebar Check Function of Dual Handle InterlockCheck Engine Crankcase Oil Check Tire PressureFill Engine Fuel Tank Check Function of all ControlsControls and Features Standard Controls OperationBrush Height Adjustment Brush Angle AdjustmentAdd Fuel to Fuel Tank Filling Fuel Tank GasolinePRE-START To Stop in AN EmergencyStarting and Shut OFF Using the Brush TravelingTransport Service Position MaintenanceMaintenance Schedule Maintenance ScheduleOperating Position Check Dual Handle InterlockClean Engine Check Clutch Cable AdjustmentClean Recoil Guard Foam Cover Check Clutch OperationGeneral Lubrication Service and Adjustments Recoil Guard Foam Cover InstallationSpeed Selector Adjustment Remove Attachment Cable Slack Attachment Clutch AdjustmentCheck Belt Finger Clearance Check Attachment Idler Arm Roller ClearanceTraction Drive Clutch Adjustment Attachment Drive Belts ReplacementTraction Drive Belt Replacement Install both wheel/tires Friction Disc ReplacementBrush Segment Replacement Joint Short Term StorageLong Term Fuel SystemService Parts TroubleshootingEngine SpecificationsSpecial Extensions Exceptions and Limitations Limitation of Remedy and Damages Page Ariens Company West Ryan Street Brillion, WI Fax
Top Page Image Contents