Ariens 926057 warranty Assembly, Tools Required, Unpacking Unit Unfold Handlebar

Page 8

ASSEMBLY

WARNING: AVOID INJURY. Read and understand the entire Safety section before proceeding.

Tools Required:

•Tire Gauge

•Pliers

•1/2-In. 3/8-In, 7/16-In, and 9/16-In Wrench and/or Adjustable Wrench

Unpacking Unit

WARNING: Dropping or tipping over boxed unit could result in personal injury or damage to unit.

Unfold Handlebar

(Figure 3)

1.Remove the lower and loosen the upper hardware on the handlebar assembly.

2.Loosen the hardware on the shift rod.

3.Put the speed selector lever in the second reverse position.

4.Rotate the handlebars into operating position.

IMPORTANT: Be careful not to damage cable spring hooks when rotating handlebars upward.

5.Install and tighten all hardware on the handlebar assembly and shift rod.

4
3
1
2
1. Handlebar Hardware
2. Shift Rod Hardware
3. Shift Rod
4. Speed Selector Lever
Figure 3

Check Function of Dual Handle Interlock

Without the engine running, press down (engage) both clutch levers. Release attachment clutch lever. Attachment clutch should remain engaged until traction clutch lever is released, then both clutches must disengage. If they do not, contact your Dealer for repairs.

EN - 8

Image 8

Contents Power Brush Table of Contents IntroductionSafety Safety Decals Locations Required Operator TrainingSafety Rules Emission Control SystemPage Page Assembly Tools RequiredUnpacking Unit Unfold Handlebar Check Function of Dual Handle InterlockCheck Tire Pressure Check Engine Crankcase OilFill Engine Fuel Tank Check Function of all ControlsControls and Features Operation Standard ControlsBrush Angle Adjustment Brush Height AdjustmentFilling Fuel Tank Gasoline Add Fuel to Fuel TankStarting and Shut OFF PRE-STARTTo Stop in AN Emergency Transport Using the BrushTraveling Maintenance Service PositionMaintenance Schedule Maintenance ScheduleOperating Position Check Dual Handle InterlockCheck Clutch Cable Adjustment Clean EngineClean Recoil Guard Foam Cover Check Clutch OperationGeneral Lubrication Speed Selector Adjustment Service and AdjustmentsRecoil Guard Foam Cover Installation Attachment Clutch Adjustment Remove Attachment Cable SlackCheck Attachment Idler Arm Roller Clearance Check Belt Finger ClearanceTraction Drive Belt Replacement Traction Drive Clutch AdjustmentAttachment Drive Belts Replacement Friction Disc Replacement Install both wheel/tiresBrush Segment Replacement Joint Storage Short TermLong Term Fuel SystemTroubleshooting Service PartsSpecifications EngineSpecial Extensions Exceptions and Limitations Limitation of Remedy and Damages Page Ariens Company West Ryan Street Brillion, WI Fax