4.4.5 HYDRAULIC CONNECTION TO THE DISTRIBUTORS
The machines that need a hydraulic connection to drive the herbicide booms are equipped with 1/2",
-proceed only with the engine turned off;
-lower any tools connected to the elevator of the tractor;
-carefully clean the two parts that will be coupled
Warning: the hydraulic cylinders used are the “Double Effect” type.
Consult the use and maintenance manual of the tractor.
4.5CARDAN SHAFT
In some models this is supplied on request. The cardan shaft must bear the CE mark.
It must always have its own instructions that must be followed scrupulously and it should come with a cover bearing the mark, integrated in every part. You should have previously checked the length to avoid:
=if it is too long, DANGEROUS THRUST ON THE PUMP SHAFT
=if too short, the POSSIBILITY OF DANGEROUS BREAKAGES
THE MINIMUM OVERLAP OF THE TWO TELESCOPIC TUBES MUST
NEVER BE LESS THAN 1/3 OF THE LENGTH OF THE TUBES.
The power that can be transmitted by the cardan shaft must be at least equal to that required to run the sprayer. Consider that the power necessary to run a sprayer without the fan is practically the same as that of the pump, the power rating can be found in the pump instructions handbook. Generally 20 bar pumps need 20 hp; 50 bar pumps need 30 hp. These power ratings can be found in tables N° 12 pages
FIG. 4
NEVER USE THE CARDAN TRANSMISSION IF THE FOLLOWING
PROTECTIVE COVERS ARE MISSING:
a)TRACTOR
b)CARDAN SHAFT PROTECTIVE COVER
c)FIXED PROTECTIVE COVER ON THE PUMP SHAFT
d)Hook any safety chains to solid anchor points
e)Check that the button or ringnut “E” (FIG. 4) is correctly engaged and blocked both on the pump side and on the tractor side.
f)Don’t exceed an inclination of
g)With the machine stopped, periodically grease the spiders and the pipes, keeping the connecting zone particularly clean.
h)Avoid letting the end of the cardan shaft come into contact with the ground with the machine stopped; use the relevant support on some versions for this, if your machine has no support, hook the external safety chain to a part of the frame of the machine (ex. control unit support).