OPERATING THE SPREADER
Variable Speed (PWM) Control
| 4 | 5 | 6 |
|
| ||
| 3 |
| 7 |
| 2 |
| 8 |
|
|
| |
START | 1 |
| 9 |
BLAST |
| ||
|
|
| |
ON |
| MIN MAX | |
|
| ||
OFF |
|
|
|
| SPINNER | SPEED |
|
1 (Emergency Stop- 3 | 2 |
| |
| OFF Position) |
|
|
1.Power Switch - used to start and stop the spinner. The power OFF position switch operates as emergency stop when required.
2.Speed Dial - used to change the speed of the spinner.
3.Indicator Lights - indicate whether the spinner is in motion. Left light is red and indicates a fault. Right light is green and indicates power is on.
Starting the Motor with Variable Speed (PWM) Control
WARNING
Before starting the spreader, the driver shall verify all bystanders are a minimum of 25 feet away from operating spreader.
1.To start the spreader motor, press the power switch to the START/BLAST position and release. This is a momentary position and the power switch will automatically return to the ON position when released. The spreader will operate at the speed selected on the speed dial.
2.To increase the speed of the spinner rotate the speed dial clockwise.
3.To decrease the speed of the spinner rotate the speed dial counterclockwise.
Stopping the Motor with Variable Speed (PWM) Control
1.Set the power switch to the OFF position to stop the motor. The power switch will remain in this position. This is also the emergency stop position.
NOTE: Always place the cover on the hopper to prevent moisture buildup. Do not let the spreader sit idle with material in the hopper for an extended period of time. This can cause the material to compact and reduce or stop the flow of the material.
CAUTION
Do not swing spreader with material in the hopper.
NOTE: The truck ignition must be on to start the spreader.
NOTE: If the truck ignition is turned off while the spreader is running, the motor will stop.
April 1, 2005 | 12 | Lit. No. 94430/94431 |