Fisher 1000-(10003), 2000-(20364) owner manual Bearing and Set Screw Maintenance

Page 18

MAINTENANCE

Bearing and Set Screw Maintenance

Disconnect the electrical plug between the spreader and the truck before performing any maintenance.

1.Tighten all set screws shown after every 60 hours of use.

2.Grease the top and bottom drive shaft bearings as shown. Due to the harsh environment of the bottom bearing it will require more care than the top bearing.

Top Bearing

Set Screw

Motor Pulley

Set Screw

Shaft Pulley

Set Screw

Bottom Bearing

Set Screw

Top Bearing: Grease after every 60 hours of use. Use a good quality multi-purpose grease.

Auger

Set Screw

Spinner

Set Screw

Bottom Bearing: Grease after every 8 hours of use. Use a good quality multi-purpose grease.

April 1, 2005

16

Lit. No. 94430/94431

Image 18

Contents Read this manual before installing or operating the spreader April 1 Lit. NoTable of Contents Preface Lit. No /94431 April 1Safety Information Before You BeginTorque Chart Metric Grade 8.8 Ft.-LbDo not Swing Spreader With Material in the Hopper Located on both sides of receiver mount only Approximate Material Weights LoadingCertification Mounting the Spreader Fixed Mount SpreaderSwing Away Spreader Receiver Mount SpreaderAccessory Circuit Operating the SpreaderDriving and Spreading on Snow and Ice ON/OFF Control Early Style PowerresetSpreader Control Starting and Stopping the MotorON/OFF Control Late Style Stopping the Motor Starting the MotorBlast Position Stopping the Motor with Variable Speed PWM Control Variable Speed PWM ControlStarting the Motor with Variable Speed PWM Control Emergency Stop OFF PositionRemoving the Spreader Postseason Maintenance MaintenanceCleaning Preseason CheckDrive Belt Replacement RecycleBearing and Set Screw Maintenance PIN Harness Wiring Diagram Vehicle Spreader Wiring HarnessChmsl Early Style BatteryVehicle Side Wiring Harness Spreader Side No Adapter RequiredTroubleshooting Problem Possible Cause Suggested SolutionON/OFF Control Mechanical Problems Variable Speed PWM and ON/OFF Control Problem Possible Cause Suggested SoulutionEarly Production 2 Pin Harness Division of Douglas DYNAMICS, L.L.C