OPERATING THE SPREADER
Spreader Control
There are two control options. They are the ON/OFF Control and the Variable Speed (PWM) Control.
CAUTION
If the unit is equipped with a SWING AWAY® mount. Do not operate the spreader or the vehicle without securing the hinge pin in the base plate.
ON/OFF Control (Early Style)
1 (Emergency Stop)
POWERRESET
OFF | ON | 15 |
|
|
2
1.Power Switch - used to start and stop the spinner. The power switch OFF position operates as emergency stop when required.
2.Circuit Breaker - used to reset the control should an
electrical fault occur.
Starting and Stopping the Motor
WARNING
Before starting the spreader, the driver shall verify all bystanders are a minimum of 25 feet away from operating spreader.
1.Move the power switch to the on position to start the motor. Motor will start immediately. The power switch will remain in this position. The power switch works as emergency stop when required.
2.Move the power switch to the OFF position to stop the motor. The power switch will remain in this position.
NOTE: The truck ignition must be on to start the spreader.
NOTE: If the truck ignition is turned off while the spreader is running, the motor will stop.
If there are problems while operating the spreader, refer to the Troubleshooting section in this manual.
NOTE: Always place the cover on the hopper to prevent moisture buildup. Do not let the spreader sit idle with material in the hopper for an extended period of time. This can cause the material to compact and reduce or stop the flow of material.
CAUTION
Do not swing spreader with material in the hopper.
April 1, 2005 | 10 | Lit. No. 94430/94431 |