MAINTENANCE
Drive Belt Replacement
Disconnect the electrical plug between the spreader and truck before drive belt replacement.
CAUTION
Overtightening the belt may result in damage to the motor or bearings.
1.Remove the motor cap assembly.
2.Loosen the four phillips head screws that fasten the motor mount to the drive support.
3.Slide the motor toward the drive shaft.
4.Remove the belt and replace with a new one.
5.Slide the motor mount away from the drive shaft until the proper tension of the drive belt is achieved. After tightening the belt should easily deflect 3/8".
Phillips Head Screws
Approx. 3/8”
Recycle
When your spreader has performed its useful life, the majority of its components can be recycled as steel. Gear oil shall be disposed of according to local regulations. Balance of parts made of plastic shall be disposed of in customary manner.
6.Tighten the four phillips head screws and replace the motor cap.
Lit. No. 94430/94431 | 15 | April 1, 2005 |