Inside Cover

7" AND 9” TWO-PIECE WRAP AROUND COVER

AND PEDESTAL

Slide the inside cover (the cover which will be closest to the inside of the pool) into position and align the hole in the cover with the cage nut attached to the top plate. Secure using the 1/4”-20 x 3/4” screw provided. Slide the outside cover onto the inside cover. Make sure the inside cover is in the slot of the outside cover. Align the holes on the side of the bottom wrap with the holes on the top of the vertical. Secure the cover using the #12 x 1/2” screws provided. The two

(2)edges of the covers should be parallel. Before tightening the screws, press the two covers firmly together.

9” WRAP AROUND COVER

7” WRAP AROUND COVER

1/4”-20 X 3/4”

STAINLESS STEEL SCREW

#12X1/2” SCREW 1 ON EACH SIDE

If your pool vertical does not have holes, simply use the cover or the pedestal as a template and drill through the vertical using a 9/64" diameter drill bit, being careful not to damage the pool wall.

WRAP AROUND PEDESTAL

Place the pedestal onto the bottom of the vertical and align the holes on the side of the wrap with the holes on the bottom of the vertical. Secure the pedestal using the #12 x 1/2” screws provided.

#12X1/2” SCREW 1 ON EACH SIDE