ViewSonic PJ656 manual Image Menu, Over Scan, Position, Phase

Multifunctional settings

IMAGE Menu

With the IMAGE menu, items shown in the table below can be performed.

Select an item using the cursor buttons ▲/▼ on the projector or remote control, and press the cursor button ► on the projector or remote control, or the ENTER button on the remote control to execute the item. Then perform it referring to the following table.

MENU [RGB]	:SELECT
PICTURE	ASPECT         4:3
IMAGE	OVER SCAN      5
INPUT	V POSITION     25
SETUP	H POSITION     142
SCREEN	H PHASE        16
OPTION	H SIZE         1344
EASY MENU	AUTO ADJUST EXECUTE

Item

Description

		Using the buttons ▲/▼ switches the mode for aspect ratio.
		For an RGB signal
		4:3  16:9  NORMAL
ASPECT		For a video signal / no signal
		4:3  16:9  SMALL
		• The NORMAL mode keeps the original aspect ratio of the signal.
		• For an HDTV signal of 1125i (1080i) or 750p (720p) as the
		COMPONENT VIDEO input, this item can't be selected.
		Using the buttons ▲/▼ adjusts the over-scan ratio.
OVER SCAN		Large (It reduces picture)  Small (It magnifies picture)
		• This item can be selected only for a video signal.
		• When this adjustment is too large, certain degradation may appear
		at the frame area of the picture. In such a case, please adjust small.
		Using the buttons ▲/▼ adjusts the vertical position.
		Up  Down
V POSITION		• Over-adjusting the vertical position may cause noise to appear
		on the screen. If this occurs please reset the vertical position to the
		default setting. Pressing the RESET button when V POSITION is
		selected will reset the V POSITION to the default setting.
		Using the buttons ▲/▼ adjusts the horizontal position.
		Left  Right
H POSITION		• Over-adjusting the horizontal position may cause noise to appear
		on the screen. If this occurs please reset the horizontal position to
		the default setting. Pressing the RESET button when H POSITION
		is selected will reset the H POSITION to the default setting.
		Using the buttons ▲/▼ adjusts the horizontal phase to eliminate
		flicker.
H PHASE		Right  Left
		• This item can be selected only for an RGB signal or a component
		video signal. Note that this does not work with the input signal of
		525i(480i)/625i(576i)/SCART RGB from the component video port.
ViewSonic	PJ656		30