ViewSonic PJ656 manual Component, Cb/Pb Cr/Pr

					Part names
			Power switch
				AC inlet
Ports (See below.)				Elevator button
				Elevator foot
	Rear-Left side		Vent
CONTROL port		Restart switch (*)
AUDIO-OUT port
			RGB IN1 port2)
AUDIO IN2 L/R port
			RGB IN2 /RGB OUT port
(In the default setting, the
AUDIO IN2 L/R port is the audio			(Use the RGB IN OUT switch to select
port for the VIDEO, S-VIDEO			RGB IN2 or RGB OUT for this port.)
and COMPONENT VIDEO			RGB IN2 port: Inputs the RGB signal from
ports, however it is possible to			a PC.
change the settings.)			RGB OUT port: When connected to a
			monitor, outputs the signal input via RGB
COMPONENT			IN1.
VIDEO ports					USB port
Y
CB/PB
CR/PR
VIDEO port
S-VIDEO port			Ports
AUDIO IN1 port			RGB IN OUT switch
			Use this button to select either RGB IN2
(In the default setting, the AUDIO
			or RGB OUT for the corresponding port.
IN1 port is the audio port for the
			When this switch is not pushed in, RGB
RGB IN1 and RGB IN2 ports,
			IN2 is selected.
however, it is possible to change
			When this switch is pushed in, RGB OUT
the settings.)
			is selected.

NOTE (*) About Restart switch: This projector is controlled by an internal microprocessor. Under certain exceptional circumstances, the projector may not operate correctly and the microprocessor will need to be reset. In such a case, please push the Restart switch by using a cocktail stick or similar, and before turning on again, make sure the projector cools down at least 10 minutes without operating. Only push the Restart switch in these exceptional instances.

ViewSonic PJ656 5