Intel ERP2U manual MultiRecord Area, Field Name PS Info Field Information Definition

SSI

	ERP2U Power Supply Design Guide, V1.0
Asset Tag	{Not used, code is zero length byte}
FRU File ID	{Not required}
PAD Bytes	{Added as necessary to allow for 8 -byte offset to next area}

8.3.3.2MultiRecord Area

As defined by the IPMI FRU document. The following record types shall be used on this power supply:

∙Power Supply Information (Record Type 0x00)

∙DC Output (Record Type 0x01)

∙No other record types are required for the power supply.

MultiRecord information shall be defined as follows:

Table 27: FRU Device Product Information Area

Field Name (PS Info)	Field Information Definition
Overall Capacity (watts)	480
Peak VA	550
Inrush current (A)	50
Inrush interval (ms)	5
Low end input voltage range 1	90
High end input voltage range 1	140
Low end input voltage range 2	180
High end input voltage range 2	264
A/C dropout tol. (ms)	20
Binary flags	Set for: Hot Swap support, Autoswitch, and PFC
Peak Wattage	Set for: 10 s, 550 W
Combined wattage	Set for 5 V & 3.3V combined wattage of 115 W
Predictive fail tach support	Not supported, 00h value
Field Name (Output)	Field Description:
	Five outputs are to be defined from #1 to #5, as follows: +3.3 V, +5
	V, +12 V, -12V, and +5 VSB.
Output Information	Set for: Standby on +5 VSB, No Standby on all others.
All other output fields	Format per IPMI specification, using parameters in the EPS12V
	specification.

- 29 -