OPTION Menu
With the OPTION menu, the items shown in the table below can be performed. Perform each operation in accordance with the instructions in the table below.
Item |
|
|
| Description |
|
|
|
| |||
VOLUME | Adjust the volume using the S/T buttons.: |
| |||
| High | Low |
|
| |
SPEAKER | Select the TURN ON or the TURN OFF using the S/T buttons.: | ||||
| TURN ON |
| TURN OFF |
| |
| When the TURN ON is selected, the | ||||
|
| ||||
IR REMOTE | Select a remote sensor using the S/T button (1), then | ||||
| switch it using the ENTER button (2).: |
| |||
| (1) FRONT | TOP REAR (2) (Off) | (On) | ||
| memo A sensor cannot be turned off when the other two are | ||||
| off. Always at least one sensor is on. |
| |||
|
| ||||
IR REMOTE ID | Select a number as an ID number for remote control using the S/T | ||||
| buttons.: |
|
|
|
|
| ALL | 1 | 2 | 3 |
|
| The projector is controlled by the remote control whose ID CHANGE | ||||
| switch is set into the position of the same number as this number. | ||||
| When the ALL is selected, the projector is controlled by a remote | ||||
| control irrespective of the position of the ID CHANGE switch. | ||||
| memo Please refer to the section “Using The Remote ID Feature”. | ||||
|
| ||||
LAMP TIME | Pressing the RESET button for about 3 seconds displays the LAMP | ||||
| TIME menu. |
|
|
| |
| Select the RESET using S button to reset the timer.: | ||||
| RESET |
| CANCEL |
| |
| Selecting the RESET resets the count of the lamp timer to 0. | ||||
| memo Perform this function only when you have replaced the lamp. The | ||||
| lamp timer counts the used time of the current lamp, to display the | ||||
| messages about the lamp. Incorrect performing causes incorrect | ||||
| operation of the messages. |
| |||
| memo About replacing the lamp, please refer to the section“Lamp”. | ||||
|
| ||||
FILTER TIME | Pressing the RESET button for about 3 seconds displays the FILTER | ||||
| TIME menu. |
|
|
| |
| Select the RESET using S button to reset the timer.: | ||||
| RESET |
| CANCEL |
| |
| Selecting the RESET resets the count of the lamp timer to 0. | ||||
| memo Perform this function only when you have cleaned or replaced the | ||||
| air filter. The filter timer counts the used time of the air filter after | ||||
| cleaning or replacement, to display the messages about the air filter. | ||||
| Incorrect performing causes incorrect operation of the messages. | ||||
| memo About caring for the air filter, please refer to the section “Air Filter”. | ||||
|
|
|
|
| |
|
|
|
| (This table is continued to the following page.) | |
ViewSonic PJ1165 | 33 |