ViewSonic PJ1165 manual Network Menu, Setup, Dhcp, Turn on Ù Turn OFF, Execute Õ Cancel

NETWORK Menu

This projector provides the NETWORK function. If you use this function, please set up the projector according to the Network environment in which you use it.

memo When you use a Network suitable to the DHCP function, the following operation is not required commonly, because the TURN

ON is selected to the item “DHCP” at the shipment time. Please see the section “Network

Setting Up”.

Item	Description
SETUP	Pressing the X (or the ENTER) button calls
	the IP ADDRESS menu.
	memo This item performs only when the TURN
	OFF is set to the item “DHCP” of this
	NETWORK menu.
	The IP Address is identification number of the projector on the
	Network.
	1. Set the IP Address using the S/T buttons.
	memo The same number as the IP Address of other units cannot be
	used.
	Pressing the X (or the ENTER) button at the
	IP ADDRESS menu calls the SUBNET
	MASK menu. The SUBNET MASK is an
	address of the Network.
	2. Set the same number as the address of
	the Network to be used.
	Pressing the X (or the ENTER) button at the
	SUBNET MASK menu calls the DEFAULT
	GATEWAY menu. The DEFAULT GATEWAY
	is the address of the main device.
	3. Set the same number as the address of
	the device as gateway to an outer Network.
DHCP	Select the TURN ON or the TURN OFF using the S/T
	buttons. :
	TURN ON Ù TURN OFF
	When you use a Network unsuitable to the DHCP
	function, select the TURN OFF.
INFORMATION	Pressing the X (or the ENTER) button
	displays the INFORMATION menu.
	The INFORMATION menu shows the
	information about the current Network setting
	as illustrated below.
RESET	Select the EXECUTE using the S button to reset the NETWORK
	menu items. :
	EXECUTE Õ CANCEL
	The items of the NETWORK menu are collectively returned to the
	initial setting.

ViewSonic PJ1165 35