Eiki LC-XB25 Lamp Replacement, Maintenance and Cleaning, Order Replacement Lamp, Top Control

Maintenance and Cleaning

Lamp Replacement

When the life of the projection lamp of this projector draws to an end, the LAMP REPLACE indicator lights yellow. If this indicator lights yellow, replace the lamp with a new one promptly.

This indicator lights yellow when the life of the projection lamp draws to an end.

Top Control

				POWER
				WARNING
		O		LAMP
		V
M	SELECT			REPLACE
L
U			M
O		+	E
V

CAUTION	CAUTION
Allow a projector to cool, for at least 45 minutes before	For continued safety, replace with a lamp of the same
you open the Lamp cover. The inside of the projector	type. Do not drop a lamp or touch a glass bulb! The
can become very hot.	glass can shatter and may cause injury.

Follow these steps to replace the lamp.

1	Turn off the projector and disconnect the AC plug. Allow the
	projector to cool for at least 45 minutes.
2	Loosen the screw with a screwdriver, and remove the lamp
	cover.
3	Loosen 2 screws of the lamp with a screwdriver and pull out the
	lamp by grasping the handle.
4	Replace the lamp with a new one and tighten the 2 screws back
	into position. Make sure that the lamp is set properly. Replace
	the lamp cover and tighten the screw.
5	Connect the AC power cord to the projector and turn on the
	projector.
6	Reset the Lamp replace counter.
	See “Lamp Replace Counter” on the next page .

Lamp Cover Screw

Screw

Lamp

Screw

Handle

ORDER REPLACEMENT LAMP

Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give the following information to the dealer.

●	Model No. of your projector	:	LC-XB25/LC-XB20/LC-SB20
●	Replacement Lamp Type No.	:	POA-LMP55(for LC-XB25/LC-XB20)
			(Service Parts No. 610 309 2706)
			POA-LMP65(for LC-SB20)
			(Service Parts No. 610 307 7925)

43