Maintenance and Cleaning
Lamp Replacement
When the projection lamp of the projector reaches its end of life, the Lamp replacement icon appears on the screen and LAMP REPLACE indicator lights yellow. Replace the lamp with a new one promptly. The timing when the LAMP REPLACE indicator should light is depending on the lamp mode.
WARNING:
TURN OFF THE UV LAMP BEFORE
OPENING THE LAMP COVER
Note:
The Lamp replacement icon will not appear when the Display function is set to Off (p.49), during "Freeze" (p.28), or "No show" (p.29).
Top Control
LAMP REPLACE indicator
Lamp replacement icon
CAUTION
Allow a projector to cool for at least 45 minutes before you open the Lamp Cover. The inside of the projector can become very hot.
CAUTION
For continued safety, replace with a lamp of the same type. Do not drop a lamp or touch a glass bulb! The glass can shatter and may cause injury.
Follow these steps to replace the lamp.
1 | Turn off the projector and unplug the AC power cord. |
Let the projector cool for at least 45 minutes. | |
2 | Remove the screw and open the lamp cover. |
3 | Loosen the two (2) screws that secure the lamp. Lift |
the lamp out of the projector by using the handle. | |
4 | Replace the lamp with a new one and secure the two |
| (2) screws. Make sure that the lamp is set properly. |
| Close the lamp cover and secure the screw. |
5 | Connect the AC power cord to the projector and turn |
on the projector. | |
6 | Reset the lamp counter.. |
See “Resetting the Lamp Counter” on the next page. |
Press here and pull upward. Lamp Cover 
Screw
Screw
Handle
Screw
Lamp
ORDER REPLACEMENT LAMP
Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give the following information to the dealer.
● | Model No. of your projector | : |
● | Replacement Lamp Type No.. | : |
|
| (Service Parts No. 610 333 9740) |
67