Intel GA-8I915PM-FS user manual Cpufan / Sysfan Cooler Fan Power Connector, FDD Floppy Connector

Page 16

English

3/4) CPU_FAN / SYS_FAN (Cooler Fan Power Connector)

The cooler fan power connector supplies a +12V power voltage via a 3-pin/4-pin (only for CPU_FAN) power connector and possesses a foolproof connection design.

Most coolers are designed with color-coded power connector wires. A red power connector wire indicates a positive connection and requires a +12V power voltage. The black connector wire is the ground wire (GND).

Please remember to connect the power to the cooler to prevent system overheating and failure. Caution!

Please remember to connect the power to the CPU fan to prevent CPU overheating and failure.

						1	Pin No.	Definition
						1	1	GND
	CPU_FAN						2	+12V
	CPU_FAN						3	Sense
							3	Sense
							4	Speed Control
							4	Speed Control
								(Only for CPU_FAN)


	1
	SYS_FAN

5)FDD (Floppy Connector)

The FDD connector is used to connect the FDD cable while the other end of the cable connects to the FDD drive. The types of FDD drives supported are: 360KB, 720KB, 1.2MB, 1.44MB and 2.88MB. Please connect the red power connector wire to the pin1 position.

34 33

2 1

GA-8I915PM-FS Motherboard

- 16 -

Image 16

Contents GA-8I915PM-FS Table of Contents GA-8I915PM-FS Motherboard Layout 8I915PM-GABlock Diagram Hardware Installation Considerations Prior to InstallationFeature Summary CPUALC880 Codec Installation of the CPU and Heatsink HT functionality requirement contentInstallation of the Heatsink Installation of Memory Dual Channel DDR Memory Configuration Install expansion cards I/O Back Panel Introduction Connectors Introduction Side Speaker OutATX12V / ATX Power Connector Cpufan / Sysfan Cooler Fan Power Connector FDD Floppy ConnectorIDE IDE Connector Azaliafp Front Audio Connector Fpanel Front Panel JumperCdin CD in Connector USB1 / FUSB2 Front USB Connector12 F11394 / F21394 Front Ieee 1394 Connector 13 IRSafemode Clrcmos Clear CmosBattery Status Page Setup Menu / Option Page Setup Menu Main MenuMain Menu For example Bios Ver D „ Load Optimized Defaults „ Set Supervisor Password„ Set User Password „ Save & Exit SetupStandard Cmos Features DateTime IDE Channel 0 Master/SlaveDrive a Halt onMemory Base MemoryAdvanced Bios Features Hard Disk Boot PriorityFirst / Second / Third Boot Device Password CheckCPU Hyper-Threading Limit Cpuid Max. toNo-Execute Memory ProtectNote CPU Enhanced Halt C1E NoteIntegrated Peripherals Pata IDE Set toSata Port 0/2 Set to Sata Port 1/3 Set toOnboard LAN Boot ROM Parallel Port ModeECP Mode Use DMA USB 2.0 ControllerPower Management Setup Power On by RingResume by Alarm Power On by MouseKB Power on Password Power On by KeyboardAC Back Function PnP/PCI Configurations INTPC Health Status Memory Frequency For Frequency/Voltage ControlMemory Frequency Mhz Load Fail-Safe Defaults Load Optimized DefaultsSet Supervisor/User Password Save & Exit Setup Exit Without SavingEnglish