Intel GA-8I915PM-FS Frequency/Voltage Control, Memory Frequency For, Memory Frequency Mhz

Page 36

English

2-7 Frequency/Voltage Control

CMOS Setup Utility-Copyright (C) 1984-2005 Award Software

Frequency/Voltage Control

Memory Frequency For

[Auto]

Item Help

Memory Frequency (Mhz)

400

Menu Level`

KLJI: Move

Enter: Select

+/-/PU/PD: Value

F10: Save

ESC: Exit

F1: General Help

F5: Previous Values

F6: Fail-Safe Defaults

 

F7: Optimized Defaults

Incorrect using these features may cause your system broken. For power end-user use only.

Memory Frequency For

Wrong frequency may make system can't boot, clear CMOS to overcome wrong frequency issue. for FSB(Front Side Bus) frequency=533MHz,

2.0

Memory Frequency = Host clock x 2.

2.5

Memory Frequency = Host clock x 2.5.

Auto

Set Memory frequency by DRAM SPD data. (Default value)

for FSB(Front Side Bus) frequency=800MHz,

1.66

Memory Frequency = Host clock x 1.66.

2.00

Memory Frequency = Host clock x 2.

2.66

Memory Frequency = Host clock x 2.66.

Auto

Set Memory frequency by DRAM SPD data. (Default value)

Memory Frequency (Mhz)

The values depend on "Memory Frequency For" item.

GA-8I915PM-FS Motherboard

- 36 -

Image 36
Contents GA-8I915PM-FS Table of Contents GA-8I915PM-FS Motherboard Layout 8I915PM-GABlock Diagram Hardware Installation Considerations Prior to InstallationFeature Summary CPUALC880 Codec Installation of the CPU and Heatsink HT functionality requirement contentInstallation of the Heatsink Installation of Memory Dual Channel DDR Memory Configuration Install expansion cards I/O Back Panel Introduction Connectors Introduction Side Speaker OutATX12V / ATX Power Connector Cpufan / Sysfan Cooler Fan Power Connector FDD Floppy ConnectorIDE IDE Connector Azaliafp Front Audio Connector Fpanel Front Panel JumperCdin CD in Connector USB1 / FUSB2 Front USB Connector12 F11394 / F21394 Front Ieee 1394 Connector 13 IRSafemode Clrcmos Clear CmosBattery Status Page Setup Menu / Option Page Setup Menu Main MenuMain Menu For example Bios Ver D „ Load Optimized Defaults „ Set Supervisor Password„ Set User Password „ Save & Exit SetupStandard Cmos Features DateTime IDE Channel 0 Master/SlaveDrive a Halt onMemory Base MemoryAdvanced Bios Features Hard Disk Boot PriorityFirst / Second / Third Boot Device Password CheckCPU Hyper-Threading Limit Cpuid Max. toNo-Execute Memory ProtectNote CPU Enhanced Halt C1E NoteIntegrated Peripherals Pata IDE Set toSata Port 0/2 Set to Sata Port 1/3 Set toOnboard LAN Boot ROM Parallel Port ModeECP Mode Use DMA USB 2.0 ControllerPower Management Setup Power On by RingResume by Alarm Power On by MousePower On by Keyboard KB Power on PasswordAC Back Function PnP/PCI Configurations INTPC Health Status Frequency/Voltage Control Memory Frequency ForMemory Frequency Mhz Load Fail-Safe Defaults Load Optimized DefaultsSet Supervisor/User Password Save & Exit Setup Exit Without SavingEnglish