Intel GA-8I915PM-FS user manual Cdin CD in Connector, USB1 / FUSB2 Front USB Connector

Page 19

10)CD_IN (CD IN Connector)

Connect CD-ROM or DVD-ROM audio out to the connector.

	1		Pin No.	Definition
			1	CD-L
			1	CD-L
			2	GND
			3	GND


			4	CD-R

11)F_ USB1 / F_USB2 (Front USB Connector)

Be careful with the polarity of the front USB connector. Check the pin assignment carefully while you connect the front USB cable, incorrect connection between the cable and connector will make the device unable to work or even damage it. For optional front USB cable, please contact your local dealer.

			Pin No.	Definition
			1	Power
	9	1
	9	1	2	Power
			3	USB DX-
	1 0	2	4	USB Dy-
	1 0	2	5	USB DX+
			5	USB DX+
			6	USB Dy+
			7	GND
			8	GND
			9	No Pin
			10	NC

English

- 19 -

Hardware Installation

Image 19

Contents GA-8I915PM-FS Table of Contents 8I915PM-GA GA-8I915PM-FS Motherboard LayoutBlock Diagram Considerations Prior to Installation Hardware InstallationCPU Feature SummaryALC880 Codec HT functionality requirement content Installation of the CPU and HeatsinkInstallation of the Heatsink Installation of Memory Dual Channel DDR Memory Configuration Install expansion cards I/O Back Panel Introduction Side Speaker Out Connectors IntroductionATX12V / ATX Power Connector FDD Floppy Connector Cpufan / Sysfan Cooler Fan Power ConnectorIDE IDE Connector Fpanel Front Panel Jumper Azaliafp Front Audio ConnectorUSB1 / FUSB2 Front USB Connector Cdin CD in Connector13 IR 12 F11394 / F21394 Front Ieee 1394 ConnectorClrcmos Clear Cmos SafemodeBattery Main Menu Status Page Setup Menu / Option Page Setup MenuMain Menu For example Bios Ver D „ Save & Exit Setup „ Load Optimized Defaults„ Set Supervisor Password „ Set User PasswordIDE Channel 0 Master/Slave Standard Cmos FeaturesDate TimeBase Memory Drive aHalt on MemoryPassword Check Advanced Bios FeaturesHard Disk Boot Priority First / Second / Third Boot DeviceCPU Enhanced Halt C1E Note CPU Hyper-ThreadingLimit Cpuid Max. to No-Execute Memory ProtectNoteSata Port 1/3 Set to Integrated PeripheralsPata IDE Set to Sata Port 0/2 Set toUSB 2.0 Controller Onboard LAN Boot ROMParallel Port Mode ECP Mode Use DMAPower On by Mouse Power Management SetupPower On by Ring Resume by AlarmKB Power on Password Power On by KeyboardAC Back Function INT PnP/PCI ConfigurationsPC Health Status Memory Frequency For Frequency/Voltage ControlMemory Frequency Mhz Load Optimized Defaults Load Fail-Safe DefaultsSet Supervisor/User Password Exit Without Saving Save & Exit SetupEnglish