Intel GA-8I915PM-FS user manual Battery

Page 22

English

16) BATTERY

Danger of explosion if battery is incorrectly replaced.

Replace only with the same or equivalent type recommended by the manufacturer.

Dispose of used batteries according to the manufacturer's instructions.

If you want to erase CMOS...

1.Turn OFF the computer and unplug the power cord.

2.Take out the battery gently and put it aside for about 10 minutes (Or you can use a metal object to connect the positive and negative pins in the battery holder to make them short for one minute).

3.Re-install the battery.

4.Plug the power cord and turn ON the computer.

GA-8I915PM-FS Motherboard

- 22 -

Image 22
Contents GA-8I915PM-FS Table of Contents GA-8I915PM-FS Motherboard Layout 8I915PM-GABlock Diagram Hardware Installation Considerations Prior to InstallationFeature Summary CPUALC880 Codec Installation of the CPU and Heatsink HT functionality requirement contentInstallation of the Heatsink Installation of Memory Dual Channel DDR Memory Configuration Install expansion cards I/O Back Panel Introduction Connectors Introduction Side Speaker OutATX12V / ATX Power Connector Cpufan / Sysfan Cooler Fan Power Connector FDD Floppy ConnectorIDE IDE Connector Azaliafp Front Audio Connector Fpanel Front Panel JumperCdin CD in Connector USB1 / FUSB2 Front USB Connector12 F11394 / F21394 Front Ieee 1394 Connector 13 IRSafemode Clrcmos Clear CmosBattery Status Page Setup Menu / Option Page Setup Menu Main MenuMain Menu For example Bios Ver D „ Set User Password „ Load Optimized Defaults„ Set Supervisor Password „ Save & Exit SetupTime Standard Cmos FeaturesDate IDE Channel 0 Master/SlaveMemory Drive aHalt on Base MemoryFirst / Second / Third Boot Device Advanced Bios FeaturesHard Disk Boot Priority Password CheckNo-Execute Memory ProtectNote CPU Hyper-ThreadingLimit Cpuid Max. to CPU Enhanced Halt C1E NoteSata Port 0/2 Set to Integrated PeripheralsPata IDE Set to Sata Port 1/3 Set toECP Mode Use DMA Onboard LAN Boot ROMParallel Port Mode USB 2.0 ControllerResume by Alarm Power Management SetupPower On by Ring Power On by MouseKB Power on Password Power On by KeyboardAC Back Function PnP/PCI Configurations INTPC Health Status Memory Frequency For Frequency/Voltage ControlMemory Frequency Mhz Load Fail-Safe Defaults Load Optimized DefaultsSet Supervisor/User Password Save & Exit Setup Exit Without SavingEnglish