Intel GA-8I915PM-FS CPU Hyper-Threading, Limit Cpuid Max. to, No-Execute Memory ProtectNote

Page 29

CPU Hyper-Threading

Enabled

Enables CPU Hyper Threading Feature. Please note that this feature is only

 

working for operating system with multi processors mode supported.

 

(Default value)

Disabled

Disables CPU Hyper Threading.

Limit CPUID Max. to 3

Enabled

Limit CPUID Maximum value to 3 when use older OS like NT4.

Disabled

Disables CPUID Limit for windows XP. (Default value)

No-Execute Memory Protect(Note)

Enabled

Enable No-Execute Memory Protect function. (Default value)

Disabled

Disable No-Execute Memory Protect function.

CPU Enhanced Halt (C1E) (Note)

Enabled

Enable CPU Enhanced Halt (C1E) function. (Default value)

Disabled

Disable CPU Enhanced Halt (C1E) function.

CPU Thermal Monitor 2 (TM2) (Note)

Enabled

Enable CPU Thermal Monitor 2 (TM2) function. (Default value)

Disabled

Disable CPU Thermal Monitor 2 (TM2) function.

CPU EIST Function (Note)

Enabled

Enable CPU EIST function. (Default value)

Disabled

Disable EIST function.

Full Screen LOGO Show

This feature allows you to show the company logo on the bootup screen.

Disabled

Displays the POST messages at boot.

Enabled

Displays the LOGO on the full screen at boot. (Default value)

Intel OnScreen Branding

This feature allows you to show the Intel brand logo on the bootup screen.

Disabled

Don't display Intel brand logo.

Enabled

Display Intel brand logo at boot. (Default value)

English

(Note) This item will show up when you install a processor which supports this function.

 

- 29 -

BIOS Setup

Image 29
Contents GA-8I915PM-FS Table of Contents 8I915PM-GA GA-8I915PM-FS Motherboard LayoutBlock Diagram Considerations Prior to Installation Hardware InstallationCPU Feature SummaryALC880 Codec HT functionality requirement content Installation of the CPU and HeatsinkInstallation of the Heatsink Installation of Memory Dual Channel DDR Memory Configuration Install expansion cards I/O Back Panel Introduction Side Speaker Out Connectors IntroductionATX12V / ATX Power Connector FDD Floppy Connector Cpufan / Sysfan Cooler Fan Power ConnectorIDE IDE Connector Fpanel Front Panel Jumper Azaliafp Front Audio ConnectorUSB1 / FUSB2 Front USB Connector Cdin CD in Connector13 IR 12 F11394 / F21394 Front Ieee 1394 ConnectorClrcmos Clear Cmos SafemodeBattery Main Menu Status Page Setup Menu / Option Page Setup MenuMain Menu For example Bios Ver D „ Set Supervisor Password „ Load Optimized Defaults„ Set User Password „ Save & Exit SetupDate Standard Cmos FeaturesTime IDE Channel 0 Master/SlaveHalt on Drive aMemory Base MemoryHard Disk Boot Priority Advanced Bios FeaturesFirst / Second / Third Boot Device Password CheckLimit Cpuid Max. to CPU Hyper-ThreadingNo-Execute Memory ProtectNote CPU Enhanced Halt C1E NotePata IDE Set to Integrated PeripheralsSata Port 0/2 Set to Sata Port 1/3 Set toParallel Port Mode Onboard LAN Boot ROMECP Mode Use DMA USB 2.0 ControllerPower On by Ring Power Management SetupResume by Alarm Power On by MouseAC Back Function Power On by KeyboardKB Power on Password INT PnP/PCI ConfigurationsPC Health Status Memory Frequency Mhz Frequency/Voltage ControlMemory Frequency For Load Optimized Defaults Load Fail-Safe DefaultsSet Supervisor/User Password Exit Without Saving Save & Exit SetupEnglish