Intel GA-8I915PM-FS user manual Safemode, Clrcmos Clear Cmos

Page 21

14)SAFE_MODE

When this jumper is set to Safe Mode, system will enter BIOS Setup directly at bootup. At this mode, the Supervisor/User Password previously configured will be cleaned.

If the BIOS file on the motherboard is damaged, set this jumper to Recovery mode. Insert the floppy disk containing the complete BIOS file and then restart the system. System will write the BIOS file to the BIOS ROM automatically at startup.

1-2 short: Normal (Default)

1

2-3 short: Safe Mode

1

Open: Recovery

1

English

15)CLR_CMOS (Clear CMOS)

You may clear the CMOS data to its default values by this jumper. To clear CMOS, temporarily short 1-2 pin.

1-2 short: Clear CMOS

1

2-3 short: Normal

1

- 21 -

Hardware Installation

Image 21
Contents GA-8I915PM-FS Table of Contents 8I915PM-GA GA-8I915PM-FS Motherboard LayoutBlock Diagram Considerations Prior to Installation Hardware InstallationCPU Feature SummaryALC880 Codec HT functionality requirement content Installation of the CPU and HeatsinkInstallation of the Heatsink Installation of Memory Dual Channel DDR Memory Configuration Install expansion cards I/O Back Panel Introduction Side Speaker Out Connectors IntroductionATX12V / ATX Power Connector FDD Floppy Connector Cpufan / Sysfan Cooler Fan Power ConnectorIDE IDE Connector Fpanel Front Panel Jumper Azaliafp Front Audio ConnectorUSB1 / FUSB2 Front USB Connector Cdin CD in Connector13 IR 12 F11394 / F21394 Front Ieee 1394 ConnectorClrcmos Clear Cmos SafemodeBattery Main Menu Status Page Setup Menu / Option Page Setup MenuMain Menu For example Bios Ver D „ Set Supervisor Password „ Load Optimized Defaults„ Set User Password „ Save & Exit SetupDate Standard Cmos FeaturesTime IDE Channel 0 Master/SlaveHalt on Drive aMemory Base MemoryHard Disk Boot Priority Advanced Bios FeaturesFirst / Second / Third Boot Device Password CheckLimit Cpuid Max. to CPU Hyper-ThreadingNo-Execute Memory ProtectNote CPU Enhanced Halt C1E NotePata IDE Set to Integrated PeripheralsSata Port 0/2 Set to Sata Port 1/3 Set toParallel Port Mode Onboard LAN Boot ROMECP Mode Use DMA USB 2.0 ControllerPower On by Ring Power Management SetupResume by Alarm Power On by MousePower On by Keyboard KB Power on PasswordAC Back Function INT PnP/PCI ConfigurationsPC Health Status Frequency/Voltage Control Memory Frequency ForMemory Frequency Mhz Load Optimized Defaults Load Fail-Safe DefaultsSet Supervisor/User Password Exit Without Saving Save & Exit SetupEnglish