Intel EK-KZPCM-UG manual Installing the 50-pin Cable Connector Onto the Host Adapter

KZPCM PCI–to–Dual Channel Ultra SCSI and 10/100MB Ethernet Host Adapter

Figure 2–4 Installing the 50-pin Cable Connector Onto the Host Adapter

NOTE

The colored stripe on one side of the ribbon cable must be aligned with pin 1 on the host adapter board. For all remaining connections on the SCSI bus, make sure that the colored stripe edge of the ribbon cable aligns with pin 1 on the SCSI device connector. Pin 1 orientation is required so that all the SCSI devices will work properly.

2.Insert the last connector on the ribbon cable into the connector on the internal SCSI device (see Figure 2–5).

2–8 EK–KZPCM–UG. B01