ViewSonic VS13789 manual ViewSonic WPD-100

Page 38

3.Start PBC pairing procedure at access point side (please refer to the instruction given by your access point’s manufacturer), then click ‘PBC’ button in wireless configuration utility to start to establish wireless connection by WPS. Please be patient (This may take a period to complete). When you see ‘WPS status is connected successfully’ message, means the connection between this wireless network card and access point is successfully established by WPS, and the information about access point you connected to will be displayed.

4.You can click ‘Detail’ button to see detailed information of connected access point. If you wish to save this connection as a profile, you can click ‘Export Profile’ button, and this connection will be saved. You can find this connection in ‘Profile’ tab in a later time.

5.Sometime WPS may fail because no WPS-enabled access point is found. If it happens, you can click ‘PBC’ button few more times to try again.

6.When an access point is connected, you can click ‘Disconnect’ to disconnect your wireless network card from a connected access point, or select another WPS-enabled wireless access point, then click ‘Connect’ to establish connection to selected access point, if there are more than one WPS-enabled access point found. You can also click ‘Rotate’ button, and next access point on the list will be selected to establish connection.

7.If you want to delete a found access point from the list, select it and click ‘Delete’ button.

ViewSonic WPD-100

32

Page 37 Page 39
Image 38
Page 37 Page 39
Contents ViewSonic Compliance Information FCC Radiation Exposure Statement Declaration of RoHS Compliance Copyright Information T a L O G Other features of WPD-100 including Safety Information System Requirements Package Contents Familiar with WPD-100 ViewSonic WPD-100 ViewSonic WPD-100 Connect to Wireless Access Point Using WPD-100 Utility Scan for Other Wireless Devices AB C DE ViewSonic WPD-100 There are 4 types of technical information To connect to the selected access point Connect to an Access Point ViewSonic WPD-100 Add an Access Point to Profile Ssid Can drag the slider to set the threshold value, or input WPA Ttls ‘Use protected authentication credential’ box, and click Here are descriptions of Profile List item Using Windows Zero Configuration ViewSonic WPD-100 ViewSonic WPD-100 Advanced Settings WMM Setting View Network StatisticsSeconds, and input ‘0’ for infinity WPS Configuration WPS Setup PBC Push-Button Configuration ViewSonic WPD-100 WPS Setup PIN SSO CCX CCXRadio On/Off AboutOn-line Help Switch to AP Mode and Basic Configuration Chapter III Soft-AP FunctionItem Name Description Permitted under FCC regulations Are in different country. For example whenBe operated. Selection of other channels is not Security Setting TypeData will not be encrypted and people with some Access Control Reject All Reject wireless clients with MAC address Connection Table AIDEvent Log Statistics Open Diagnostic Testing Mode Chapter IV Appendix Specification Troubleshooting An access point with encryption. Please Customer Support Limited Warranty
Top Page Image Contents