Nikon AX-110 manual Connecting the Scanner, Before Connection

Page 26

4. Connecting the Scanner

4. Connecting the Scanner

4.1Before Connection

Before connecting the cables, confirm that all devices, including the computer system and the scanner, are turned off.

Power OFF

For an IBM PC/AT or compatible in which a SCSI board has not been installed, install a SCSI board as explained in the manual supplied with the board.

Note: Make sure that the PC is powered off before installing the SCSI board.

When installing a SCSI board for the first time, be careful not to set conflicting I/O addresses, interrupt numbers, or graphic board DMA channels.

16	Nikon ScanTouch 110 User's Manual

Image 26

Contents Page Page ScanTouch Flatbed ScannerIndication Trademark InformationImportant Safeguard Wichtige SicherheitshinweiseModifications Scsi CableWhen Taking the Unit Out of The Country Items prohibited by law from being copied or reproduced Contents Operation Overview Power Supply Precautions Before Operating the ScannerShape of the plug depends on the country of use Handling Precautions RemarksBefore Operating the Scanner Before Operating the Scanner Do not store or use where If You Notice Anything AbnormalStorage and Operating Locations Before Operating the Scanner Before Operating the Scanner Transportation Precaution Components Parts IdentificationInspection Scsi cable Power cord Main Body Closer LookRear View Unlocking the Scanner Connecting the Scanner Before ConnectionConnecting the Power Cord Remarks Connecting the Scsi Cable Connecting to the Macintosh computer Scsi Chain Connection with Other Devices Remarks Setting the Scsi ID Turning on the Power OperationOperation Setting a Document Step Close the document cover gently Maintenance Static Electricity PrecautionsCleaning If the scanner lamp flickers, is dim, or fails to come on TroubleshootingIf the Power indicator fails to come on Troubleshooting If All Else Fails Appendix Specifications Environmental Ranges DimensionsNet Weight Systems SupportedSymbols IndexEC Declaration of Conformity