Nikon AX-110 manual Remarks

Page 32

4. Connecting the Scanner

Remarks

•The maximum number of SCSI devices that can be connected to one computer is eight including the CPU. When using the scanner with a host computer with a built-in SCSI hard disk or built-in CD-ROM, note that SCSI ID numbers have been preassigned for the host CPU and the SCSI devices.

•The SCSI cable must not be extended beyond a total length of 19 feet (6 meters), or else failure may result.

•Terminators must be attached to the devices located at both ends of the SCSI chain.

If the host computer is a Macintosh, the Macintosh itself will provide termination at one end of the chain.

If the host computer is an IBM PC/AT or compatible, equipped with a SCSI board, the SCSI board itself will provide termination at one end of the chain.

Note that when a SCSI chain connection is made inside a computer, the end of the SCSI device inside the computer will become the end terminal.

•Before installing a SCSI board, be sure to read the user’s manual provided with the board. The numbers for the I/O address, interrupt level (INT) and DMA channel might conflict with other interface boards and peripheral devices. If so, change them as explained in the manual.

22

Nikon ScanTouch 110 User's Manual

Page 31 Page 33
Image 32
Page 31 Page 33
Contents Page Page ScanTouch Flatbed ScannerIndication Trademark InformationImportant Safeguard Wichtige SicherheitshinweiseModifications Scsi CableWhen Taking the Unit Out of The Country Items prohibited by law from being copied or reproduced Contents Operation Overview Power Supply Precautions Before Operating the ScannerShape of the plug depends on the country of use Handling Precautions RemarksBefore Operating the Scanner Before Operating the Scanner Do not store or use where If You Notice Anything AbnormalStorage and Operating Locations Before Operating the Scanner Before Operating the Scanner Transportation Precaution Components Parts IdentificationInspection Scsi cable Power cord Main Body Closer LookRear View Unlocking the Scanner Connecting the Scanner Before ConnectionConnecting the Power Cord Remarks Connecting the Scsi Cable Connecting to the Macintosh computer Scsi Chain Connection with Other Devices Remarks Setting the Scsi ID Turning on the Power OperationOperation Setting a Document Step Close the document cover gently Maintenance Static Electricity PrecautionsCleaning If the scanner lamp flickers, is dim, or fails to come on TroubleshootingIf the Power indicator fails to come on Troubleshooting If All Else Fails Appendix Specifications Dimensions Net WeightEnvironmental Ranges Systems SupportedSymbols IndexEC Declaration of Conformity
Top Page Image Contents