Note the following when loading tapes:
1Use your finger or a pencil to turn the cassette's hub and take up any slack tape.
NOTE
Avoid touching the tape. Fingerprints attract dust and dirt.
7- Cassette operations
2Press the EJECT key to open the cassette com- partment door.
3Load the cassette tape with its open edge facing down.
4Gently close the compartment door.
NOTE
The cassette holder cannot be opened during recording or playback.
If the power has been switched off during play or recording, ejecting the cassette may be impossible. In such a case, switch the power on and press the EJECT key again.
Playback operations
WARNING
If you are monitoring using headphones, first adjust the level control to low on the unit, then connect to the POHNES jack before playing back. This will pre- vent any possible damage to your hearing.
1Set the REV MODE switch to the required tape mode.
Ä
ËOne side, then the other side, then stop
ä One side, then the other side, then the first side again, etc.
2Load a
3Set the DOLBY NR system on or off.
4Press either PLAY key to start playback.
5Adjust the volume with the amplifier’s volume control.
6To stop playback, press the STOP key.
Also, check the monitor switch is set to tape.
Continuous tape/CD playback
1Load the tape as described above into the unit. Load the disc recorded side downwards using the
OPEN/CLOSE key.
2Press the
3Press either of the PLAY keys of the tape deck, or the PLAY key of the CD deck.
Playback will start on the appropriate unit. When playback reaches the end of the disc, or the end of the tape as determined by the REV MODE setting, playback starts on the other unit.
NOTE
Media (tape or disc) can be changed in the unit that is not playing.
4To stop playback and cancel the mode, press the
NOTE
The cassette deck and CD deck can be used to play back through different outputs, or the LINE OUTPUTS 2 jacks can be used for both disc and tape playback. However, note that if both are play- ing, the cassette takes priority (the disc will not be heard through these outputs). Disc playback is always through the LINE OUTPUTS 1 jacks.
TASCAM