Tascam CC-222MK owner manual Reference and specifications, Error messages

Page 33

	8- Reference and specifications


Error messages

Message	Details / Response
Cannot Rec!	Use unfinalized recordable disc.
Disc Error!	If it is CD-RW disc, you may refresh it (“Refreshing a disc” on page 28),
	or replace disc.
Disc Full !!	There is no space on disc, or no tracks are available.
Drive Error!	There is problem with the Drive mechanism.
D-IN UNLOCK!	Digital input is not connected. Turn on power of source unit and
	connect to DIGITAL IN.
Cannot ERASE!	The disc does not support erasing.
Erase Error!	An error has occurred while trying to erase disc.
Not Fs 44.1k!	The sampling frequency of digital input is not 44.1kHz.
	Please turn SRC on (“Frequency conversion” on page 20).
PGM Full !	An attempt has been made to create more than 99 tracks.
Rec Error	A general recording error. Try recording again with different disc.
System Err!	System Error. Try turning the power off and on again.
Tray Error!	There is a problem with the CD tray.

Messages displayed during normal operation

Message	Statement
Complete	An operation such as finalize or erase has been successfully completed.
Now OPC	Calibration is being performed to operate recording properly.
Now REPAIR	The disc is being repaired and this operation will take a long time.
	Please do not turn off power of the unit until it finishes.
PMA Writing	Recorded content is being written to disc.
TOC Reading	Table of contents data is being read.
REC Standby	The unit is in recording standby mode.
Blank Disc	A blank recordable disc has been inserted.

TASCAM CC-222MKIII 33

Image 33

Contents CC-222MK$ Important Safety Precautions Important Safety Instructions Optical pickup Safety InstructionsContents Introduction Supplied accessoriesRack-mounting the unit Some notes, precautions and environmental considerationsBeware of condensation Never use a stabilizer or printable discsHandling of compact discs About CD-R and CD-RW discsAbout tapes FinalizingAbout this manual Recordable discsBatteries Use of the remote control unitFront panel Features of the CC-222MK$Rear panel Display RC-222 Remote control unit Menu operation Menu configurationSimple playback operations Disc operationsTime display modes Track searchPlayback modes Random playbackProgram playback Auto spacing Intro checkRepeat playback To B repeat playbackPlaying back MP3 files Directory playback settingRecording CDs Signal volumeInput selection Input monitoringTurn the Multi dial to set the value on or OFF Basic recordingTime display while recording Recording to disc from the Riaa Phono inputsPlaying back tracks Restricting the number of tracksDubbing from tape to disc Dubbing to CD from the middle of the tapeBypassing the Input level for dubbing Setting the trigger level Using the trigger levelAdvanced recording Automatic track division Synchronized recordingManually divide track Fade-in and fade-out Rec mute functionCopy-protection After recording ErasingUnfinalizing CD-RW discs Erasing tracks Erasing a whole discRefreshing a disc Cassette operations Playback operationsContinuous tape/CD playback Dubbing tapes from the CD deck Recording operationsDubbing to tape from the middle of a CD Recording tapes from the Phono deckOther tape functions and features Other recording featuresReference and specifications Error messagesMessages displayed during normal operation Specifications CD recorder sectionCassette recorder section Dimensional drawing Phono input and headphonesGeneral specifications CC-222MK$