Lenovo TD230 manual Removing a memory module, Opening the retaining clips of the memory slot

4. Open the retaining clips of the memory slot into which you want to install the memory module.

Figure 17. Opening the retaining clips of the memory slot

5.Touch the static-protective package that contains the new memory module to any unpainted metal surface on the outside of the server. Then, remove the new memory module from the package.

6.Position the new memory module over the memory slot. Make sure that the notch 1 on the new memory module is aligned with the key 2 in the memory slot. Then, press the new memory module straight down into the memory slot until the retaining clips close and the new memory module snaps into position.

Note: If there is a gap between the memory module and the retaining clips, the memory module has not been correctly installed. Open the retaining clips, remove the memory module, and then reinstall it into the slot.

Figure 18. Installing the memory module

7. To complete the installation, go to “Completing the parts replacement” on page 122.

Removing a memory module

Attention:

Do not open your server or attempt any repair before reading and understanding the Safety Information and the Warranty and Support Information on the ThinkServer Documentation DVD that came with your product, and “Guidelines” on page 39. To obtain a copy of the publications, go to:

http://www.lenovo.com/support

This section provides instructions on how to remove a memory module.

To remove a memory module, do the following:

Chapter 5. Replacing FRUs 51